This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

99 wheel into 02/03 swingarm

Joined Jan 2006
28 Posts | 0+
Notts UK
Hi guys

Still persevering and just got hold of a 2003 550 swingarm and 2003 650 FS shock.

On the basis that a 98/99 swingarm fitted in a 2000+ frame no problem, I'm assuming that I can reverse that particular piece of reverse engineering and put the newer back end in.

Q1 - should it fit without a fight ( or should I just swap the shocks, as mine is bouncy - no damping)?

Q2 will the 98/99 wheel fit without new spacers or other gubbins straight into the 03 swingarm?

Q3 - is the steering head on the 2000+ frame longer than the 98/99 Estart frame.

This last bit has been bugging me since i blew my 99 FE 400 E-start, and bought a FE600 98 (I think) engine, and ended up buying a frame and sticking both ends of my 99 on it - the top steering head nut doesnt go down far enough onto the stem ie you can see the threads inside the nut which doesnt feel right to me!I did wonder whether the bearings were different but dont think they are?

PS noting that thread about breaking a bike when you dont need to, do like i did and park it in the garage til you get enough money to fix it, a bit at a time
 
hi, my 97 has the same issue with the top yolk threads, are you putting a linkless back end onto an early frame then? i was wondering about doing this myself so i can lose the linkage and use a newer wheel and possibly a bigger rim width too.
 
The 2003 swingarm fits as does the shock though not sure if its the same length. The chain adjuster plates dont fit in the new swingarm tho, and therefore need new uns which is a pain

Not happy about the steering head locknut showing so much thread still, but then i only wanted a trail bike in the forst place not a racer.... silly me eh!
 

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions