Joined Mar 2009
1K Posts | 251+
Portugal
Hi
If you want to make one, it's relatively easy.
Here you have some ideas.
In the end you should make some holes, specially in the bottom, so the dirt goes out when you wash the bike. I ended up with most of he bottom cut out, almost only protecting the frame tubes.
Good luck
ZAGA
If you want to make one, it's relatively easy.
Here you have some ideas.
In the end you should make some holes, specially in the bottom, so the dirt goes out when you wash the bike. I ended up with most of he bottom cut out, almost only protecting the frame tubes.
Good luck
ZAGA
Attachments
Joined Sep 2015
22 Posts | 12+
Gold Coast, Aussie
Thanks Zaga, appreciate the photos and ideas. I've mocked up a couple in cardboard but the main issue is with the older models frames the bike does not sit flat on a stand, they have a 3rd rail in the center that has a factory bend that sits about half an inch lower than the outside rails, getting something functional but also not looking too agricultural is the challenge.
Attachments
Last edited:
Joined Mar 2009
1K Posts | 251+
Portugal
Hi
You can make 2 spacers and use the outside tubes or just use the central one, as fixing points.
On the front it's also different, you must use the engine mounts plates and make some brackets, on the central tube should be more difficult to make one at home.
I wouldn't say it's impossible
Good luck
ZAGA
You can make 2 spacers and use the outside tubes or just use the central one, as fixing points.
On the front it's also different, you must use the engine mounts plates and make some brackets, on the central tube should be more difficult to make one at home.
I wouldn't say it's impossible
Good luck
ZAGA
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
