2011 fe 450 no spark /fuel pump

Glenny · Sep 4, 2020

I have a 2011 fe 450 was running son washed it no no spark no
Power to fuel pump
Just bought the bike second hand wiring looks to be std mo monster stuff
Cheers

Rainerio · Sep 4, 2020

Check fuses under the seat. If not push the starter for a second listen for fuel pump if it does make noise I’d say bad pump. Loose connections?

TnT · Sep 6, 2020

Check power to fuses first. If fuses all have power while cranking (both sides of the fuses) then check for water in the computer harness where it plugs in.

cambo · Sep 9, 2020

Pull the spark plug cap off pull out the threaded lug with pliers clean off the carbon reassemble . Be carful a resistor will be pushed out from an internal spring do it in a location that you won’t lose the resistor . Test it should be 5k ohms these bikes were plagued with flameouts years later I found this is one of the reasons .

TnT · Sep 10, 2020

cambo said:
Pull the spark plug cap off pull out the threaded lug with pliers clean off the carbon reassemble . Be carful a resistor will be pushed out from an internal spring do it in a location that you won’t lose the resistor . Test it should be 5k ohms these bikes were plagued with flameouts years later I found this is one of the reasons .

That wouldn't cause no power to the fuel pump

NoClassic · Sep 11, 2020

The most common area for the harness to be damaged on these is where it runs against the frame next to the rear damper/spring. If there is abrasive damage moisture could have entered during the wash. I would have a close look in that area along with confirming no water damaged the engine stop or start button on the handle bars.

Another area to check are the two hex screws and spade connectors on the primary engine power relay that sits on top of the battery.

Search

Search

2011 fe 450 no spark /fuel pump

Glenny

Rainerio

TnT

cambo

TnT

NoClassic

Similar threads

Register CTA

Recent Discussions