This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

2008 FE 550 Rear Shock Lower Heim joint bearing cover replacement

Joined Mar 2017
99 Posts | 15+
Vancouver, BC
Hi,

Took the 2 x covers off the lower joint/bearing. Bearing itself looks and feels good (no radial, lateral, or longitudinal play). But I damaged the two covers in the removal.

Don't need the whole bearing replaced - just those two cover rings. Looked high and low, and can't find those - anyone have a part number?

Again, no need for the whole bearing replaced, just the two covers.

thanks,

cm
 
here you go!

80004041000 and I THINK?????? they come with an O ring but I can;'t recall 100% ask about them when ordering but you do need an O ring.

cheers

taffy
 
Hi Taff,

Thanks for the reply. I likely shouldn't have said "cover", the cover part in your number is not what I'm after.

The part I'm after is a rubber-coated ring seal-cover type part, and it covers the round / gimbal part of the Heim joint.

I brought it with me here at the office to try and source the ring - so I don't have a picture of it installed - but here is my quick and dirty drawing, with the actual part, and where it sits.

Thanks,

cm

PS: I say "it" - but there's a pair of them, one on each side of the shock's Heim joint.
 

Attachments

  • IMG_6594.jpg
    IMG_6594.jpg
    73.9 KB
Last edited:
Ah - solved (I think).

SHAFT SEAL RING KGW D=32 (50180159).

Given that I've measured OD = 32/ID=25/H=7, I'm hoping that's the part.

Will advise when they arrive next week.

cm
 

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions