Hello, im new to the page, and i am the new owner of a 1997 husaberg fe600e supermoto built on supermotojunkies.com. i bought the bike barley running, backfiring and loss of power before half throttle, basically to make a long story short i figured out my flywheel and stator are bad, the previous owner said the stator bolts werent tightened and it caught up on the flywheel. So ive been looking for a flywheel and i cant fond one, my question is, is there somewhere i can get a flywheel or is there one that is compatable through ktm, or husky? Thanks for any reply, id love to get this thing on the road and anything helps.
1997 Husaberg Fe600e
- Thread starter Fe600eSupermoto
- Start date
Joined Dec 2004
2K Posts | 247+
back in cottonwood, az
just keep your eyes on ebay for any flywheel for any size '89-'98 model fe. you can get your stator rewound by searching the website. or just Contact - Husaberg, Husaberg Parts, Taffmeisters UK
Joined Nov 2001
17K Posts | 773+
Ely, England
i'm going to bet that the flywheel is OK. it is the stator.....
they can suffer those pre '99s. I have found that the ignition timing was wrong, the tappets were wrong, the carb was completely phuqed and they had basically kicked the shi* out of them!!!!
I do some videos on the pre 2000s on my Faceboook page. Ned is right, my tickover was too high and this altered the ignition timing, luckily it was still correct.
6d BTDC at a lower idle = correct
7d BTDC on a higher idle = the above plus a few revs.
regards
Taffy
they can suffer those pre '99s. I have found that the ignition timing was wrong, the tappets were wrong, the carb was completely phuqed and they had basically kicked the shi* out of them!!!!
I do some videos on the pre 2000s on my Faceboook page. Ned is right, my tickover was too high and this altered the ignition timing, luckily it was still correct.
6d BTDC at a lower idle = correct
7d BTDC on a higher idle = the above plus a few revs.
regards
Taffy
I wish i still had a factory stator so i could just get it rewound and see what happens
Joined Nov 2001
17K Posts | 773+
Ely, England
you need to stop whinging fella. and you are whinging.
send your flywheel and stator to me here in the UK and I will test them on my 1998. I charge £30 which is about $45 plus about $15 home OK? if the stator is faulty then there is no charge for this service but you pay for the repair instead.
then we can put all this to bed can't we?
Taffy
send your flywheel and stator to me here in the UK and I will test them on my 1998. I charge £30 which is about $45 plus about $15 home OK? if the stator is faulty then there is no charge for this service but you pay for the repair instead.
then we can put all this to bed can't we?
Taffy
Last edited:
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
