Hi I’m working on a 1992 Husaberg fe350 and ran into a problem the threads on one of the valve adjustment bolts are in pretty bad shape. Just wondering if anyone knows where I can get a new exhaust valve rocker for it. If not could I take it to a machinist and get a helicoil of the same sized thread installed and would it still have the same strength in order to work properly?
Help damaged rocker arm threads
- Thread starter Motohead92
- Start date
Joined Feb 2018
16 Posts | 1+
Holland
Just tap the thread yourself, if it isn't strong enough put a helicoil in, this will work properly
Joined Nov 2001
17K Posts | 773+
Ely, England
Motohead, I sell M7 tappet pads and nuts so you would drill out to 6.25mm and then tap the holes to M7. do an imperial to metric check and see if you can buy 6.25-6.5mm but in imperial.
I also do the rocker bishes too. and the rocker shafts.
Taffy
I also do the rocker bishes too. and the rocker shafts.
Taffy
Joined Nov 2001
17K Posts | 773+
Ely, England
I suppose you've **** yourself over this one have you?
OK, I just set you a little tease, I couldn't help it! I like to see the energy drain out of people when I explain in simplistic terms what to do and watch the pee running down their leg.
1/4" drill bit is the equivalent of 6.35mm and is therefore PERFECT.
Taffy
OK, I just set you a little tease, I couldn't help it! I like to see the energy drain out of people when I explain in simplistic terms what to do and watch the pee running down their leg.
1/4" drill bit is the equivalent of 6.35mm and is therefore PERFECT.
Taffy
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
