This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Kickstart wont come back up

Joined Aug 2021
27 Posts | 1+
Finland
So I bought my bike without the kickstart arm. The seller said that only thing missing was the arm and everything else would be fine. Try to guess was that the case :D. When I installed the kickstart arm it was really, REALLY hard to get it moving, even with the decomp lever. Eventually I got it to move (somewhat forced it down) but then it wouldn't come back up. The bike does start with the kickstart and what I've managed to listen it doesn't seem to make any weird sounds while the bike runs and the kickstart arm is down. My only guess is that the kickstart as a whole has been assembled incorrectly or the spring is broken/misplaced

It's 12pm and I'm wondering why I didn't buy a KTM :D
 
Because a KTM isn't a BERG!
Might be worth taking the side cover of and having a look if you haven't already, like you said return spring could be a likely culprit, or not evnough pretension on the kickstarter on assembly? If the kickstarter and side cover isn't installed correctly it can also "lock" the kickstarter I think?
 
So I bought my bike without the kickstart arm. The seller said that only thing missing was the arm and everything else would be fine. Try to guess was that the case :D. When I installed the kickstart arm it was really, REALLY hard to get it moving, even with the decomp lever. Eventually I got it to move (somewhat forced it down) but then it wouldn't come back up. The bike does start with the kickstart and what I've managed to listen it doesn't seem to make any weird sounds while the bike runs and the kickstart arm is down. My only guess is that the kickstart as a whole has been assembled incorrectly or the spring is broken/misplaced

It's 12pm and I'm wondering why I didn't buy a KTM :D

go into FB and Taffmeisters and videos and there is one there of putting the kick start shaft in correctly.

I suggest that if there is a chewed and ficked look to the sledge plate, you put a couple of 1mm washers behind it. to draw the plate out towards YOU.

then fit the sledge plate and the k/s shaft. then the rest.

Taffy
 
I took the side cover off and the kickstarter moved quite a bit, like the whole assembly wiggled a good bit. The needle bearing in front of the shaft was out couple millimetres so I pushed it back in. Do I have to take a part the whole clutch side of the engine to re install the kickstarter
 
I took the side cover off and the kickstarter moved quite a bit, like the whole assembly wiggled a good bit. The needle bearing in front of the shaft was out couple millimetres so I pushed it back in. Do I have to take a part the whole clutch side of the engine to re install the kickstarter

yes you do. remember that the two similar gear to the left are timed to each other via the clutch basket. look for a single dot on one gear and a two dots on the other gear.

Taffy
 
  • Like
Reactions: 1 person
Similar inquiry, if my bike starts and runs perfect with electric start but the kicker is stuck and won't move, will any damage occur? That is, do I need to repair it before riding it again? 07 FE450
 
Taffy, what do you mean by the two gears next to the clutch basket are timed to each other? Do I have to make sure they are in certain position before putting everything back together. There is a chance that the gears have moved a bit so is the engine off time now or what?
 
I just re assembled the engine and try to guess did i manage to start the bike. I did not. Does the engine for real go off timing when disassembling the cluth? Or do I just suck at kicking the bike? It ran for a brief moment, like a second but then died and that was all I got.
 

Register CTA

Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Recent Discussions