wiring

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    2003 FE400E Digital Speedometer PCB repair

    Hi all A battery issue resulted in damaged to digital speedometer on my FE400e. Good knews is that the unit in fact survived, still powers on and works of the 3V CR battery (had to be replaced), but no longer powers up from the bike and also backlight doesn't come on. Thankfully all of the...
  2. G

    2001 Fe501 - No Spark

    Hello all! I recently picked up a 2001 fe501, and it had no wiring harness and the old stator had been removed, as it had a big chunk taken out of it. The previous owner raced it, so it had the starter motor and battery removed for weight. I purchased this stator as a replacement: Stator Coil...
  3. K

    2014 TE300 headlight issues!!

    Hey guys, bought a te300 2014 recently, wiring was a bit of a mess. Headlight and tailight never worked since I got it. Got everything sorted and together, and I’m getting negative volts at both the headlight terminals? One on the side shows nothing so I assume it’s grounds. Is this something to...
  4. D

    2011 FE turn signal wiring

    anyone have a wiring diagram for a euro fe390 or know what wiring colours are for turn signals and location of plugs? One of the bits I need for road legal so want to get them sorted soon:(
  5. DOLLARS

    2004 501fe wiring harness

    Hi all just wondered if anyone has tried fitting a ktm exc harness to they’re bike most things seem to be in a similar place maybe the starter solenoid and regulator maybe in a different position just wondered if it maybe possible as the berg loom is no longer available but the ktm one seems to...
  6. A

    FE 501 / 601 -1997 wiring harness pictures

    Hello, I bought bike in a box, would anyone have pictures how wiring harness is routed and what kind of mounts it has? Any pictures would be helpful! Thank you!!
  7. A

    For Trade Want to Buy: 601 / 501 wiring harness 1997

    Hello, intrested to buy good condition harness. Preferrably from USA, im located in FL Thanks!!
  8. D

    Questions re early FE501 Wiring diagram

    I could use an early FE501 schematic to finish wiring my bike. The PO had removed most wires and kept a bare minimum like a MX bike. Meanwhile I have some questions: 1) on the 95's ignition module, there is one wire that is a mystery. The red one. Is that a power-on wire or is it a shut-down...
  9. K

    husaberg fe 450 07 wiring diagram

    looking for wiring diagram on husaberg fe 450 -07... i have found the -09 diagram, but seems that isn't the same :eek: ? im a still novice on these bikes electricity so i could use a little help on this one...:)
  10. FraserThompsom

    FE650 Wiring Loom, does this look right?

    Hi guys, I have followed everyone's advice on here so far and have managed to make my 2002 FE650 start on the second / third kick. It is kick start only and I but has the Sprague bearing and everything in the crank case (assumably a previous electric start then stripped). I have found...
  11. FraserThompsom

    FE650 Wiring Loom (Kick Start Only)

    Hi Guys, I have just bought my first Husaberg and its a 2002 FE650 but it is kick start only. I have a base knowledge about Husabergs and lightly know my way around a bike. It is kick start only and has no Battery, ECU, starter motor etc but I believe it has a rectifier. I'm just...
  12. B

    Want To Buy main wiring harness

    Looking to buy a main wiring harness for 2010 husaberg fe390 any leads or help is greatly appreciated.. anyone have cross reference numbers to a ktm that I could use or any ideas ? I did purchase one from Australia and the Australia post lost it and I’m having a hard time finding one now .
  13. M

    Building complete wiring from scratch? Too much loose wiring and too many cables

    Hi! Wondered if anyone has tried or completed - building completely new wiring set-up on a Berg ? I have a 2008 650, and I am planning to start with this: M-UNIT Blue ! anyone read about it or tried to use it to build a new simpler electrical system...
  14. C

    Wiring and hoses near exhaust on FE550

    Hello all, As the rebuild is almost done, I noticed as I was running the motor for a minute or so that I had melted the carb vent hoses, as shown below. Those hoses are just PVC or polyurethane (I can't recall which) to replace the old ones. I think the temp rating is only around 70C. I...
  15. K

    Husaberg fe 350 1992 wiring?

    Does anyone have wiring diagram?
  16. H

    2013 TE300, Bungled Speedo Wiring

    Hey, Got a 2013 TE300. Speedometer doesn't track anything or power on unless I press the button. Previous owner clearly played around wiring a headlight and now coming out of my speedo is this plug (photo attached) with nothing to connect to! Is this supposed to plug into something? Does...
  17. B

    Fe 390 wiring pinout for horn

    Hi guys I have tried flicking through the search area to find this answer but to no avail, I know the horn wires are usually short and down hidden in the frame but weather the previous owner has chopped the I cant find it. What I wanted to do was to find where the two wires start from behind...
  18. C

    Wiring Diagram TE 250 2014

    Hello, Can anyone help me with a wiring diagram for HUSA TE 250 2014 or a complete repair manual? Thanks
  19. M

    09 FE570 rear indicator wiring

    Hi Guys, Trying to wire in the rear indicators for my FE570. Having trouble finding the wires, can't seem to find anything under the seat Up the front I noticed these connectors tied into the front indicators. Is this where the rear indicators were and they have cut them off or are these...
  20. T

    Ignition module wiring, where to?

    Hi! I'm currently swapping the engine in my FE450 -06' to a 550 -03'. As you probably know they are operating on different ignition systems and I am trying to do the necessary swaps in the wiring for this to work (switching to the old models ignition module and regulator). I think I have...
Back
Top