swap

Anybody interested, if so let me know. So we can exchange full details. Dont think I'm quite ready for the almighty 550 just yet. Bike is in Excellent condition, with many extras.

Quick question, do 2002 triple clamps fit in the 2008 frame? Regards, Christof.

Anyone want to swap a blue 18" rim from a 2009/2010 Berg for my 19" rim off my 2010 FX450? I'm looking to go back to an 18" rim since that is what I'm used to and I like the tire selection better. I'm in Virginia, USA. Looking to swap rim, spokes, hub, complete.

Bergers, I have a quandry. I've been battling with my poor 98 for some time now. After the roller gave a while back, it's been a chain reaction. Then the tappet locknut after I adjust valves improperly, broke free and chewed the timing chain, which then snapped and link pieces gouged the...

I have a 2001 FE501 and the stator has gone south. There is a 2001 FC550 engine for sale that has a stator. Will this stator work in my FE501 and also are many of the other parts interchangeable? Thanks in advance!

I've recently acquired an '07 Husaberg FE550, couple of upgrade questions... I find it difficult to find aftermarket mufflers for the Berg. As the muffler is a KTM part (model K 620) does that mean that any aftermarket muffler that replaces the K 620 for a KTM (eg 525 exc) will fit the...

Ho hum Some of you might remember my sad tale of woe with my 99 berg elduro 400. I've got the chance of a 450E 04 engine complete... I know it wont drop straight in (I doubt anyway) but has anyone tried anything similar From previous thread, the back fits (hopefully) but the front...

HI Need a little help,will a 2002 650 engine fit straight into a 2002 470 bike ?. I know where there is one for sale close to me and am interested if it is not going to cost a fortune and i can use all the running gear that i already have,coil,carb,airbox,etc.If all that has to be changed...

I have a 2004 fe450 and I wanted to know if the ktm triple clamp with the 20mm offset will interchange with my berg set(22mm)?? Any special dohickies needed to make it work?

Hey guys, long time no see. Everyone doin well I hope. Anyway, I was wondering if the engine out of my '99 FE400 would bolt directly into a '00 model FE400 frame without any mods? Thanks, Jay

I have a chance to pick up a tank for my 1995 Fe 501, the tank being sold is off of an 1996 Fc 501, I'm pretty sure the mounting is the same, but I'd like to be sure. It's of little value if the capacity is smaller. but if they're the same, I'll probably get it. Thanks Sandy

My '95 FE501 supermoto has a 38mm Dellorto carb, I've noticed that newer models have a 40mm carb. I'm wondering if the 40mm will bolt right on, or require a new intake manifold? Also what kind of power gain can I expect?

I am swapping an enduro tank (FE501 -95) for a motocross tank (FC501-98) for a supermoto set-up. My main concern is that to make the tank fit, I have to remove the forward air filter. I think that I have to remove the filter and block off the frame openings, just leaving the filter under the...

:twisted: :lol: I have been having problems with my 02 470 not starting that great from hot or cold and when i drop it its been a pig to start. I spoke to taffy at a local enduro and done the usual bigger battery new stator new plug adjust tappets ect but it still dont start right. I then...