stock

Anyone know stock sprocket sizes for a 96 fc 501. looking tobuy a set of highway gears for it

is the stock jetting for 06 fe450 the best? if not, any pilot, main, or needle sudgestions? thanks in advance.

I've looked all over this site, and in my manuals and can't find what the height of the fork should be(as measured from the top of the triple tree). Anyone know? I bought the bike used, and i'm suspecting it was modified, and I want to go to factory settings before I start tweaking...

just got the bike (05 fe550) delivered and deboxed it during lunch. i was scratching my head looking at the battery. it looks like i should slip the little teeny rectangular 'nuts' into the battery terminals, then screw the battery wires in from the top. naturally, the screws don't actually...

I finally sat down and read carefully the owner's manual instructions on operation of the Husaberg/ktm electronic speedometer. I hate reading these type of instructions like programming a VCR or setting a hand wrist watch display........but I need to learn what the stock unit can do because I...

I did a search but couldn't find what the stock HP is for an 05/06 fe450e. What about the 550 and 650?

perhaps some one can enlighten me.we just prepped a new 2005 fe 650e.pipes started discoloring immediately.we jet all the bikes we sell, but the stock jetting in this model baffles me.it had a 38 pilot,160 main and the needle was set on the 2nd from leanest position.a 550 comes with a 182 main...

Hi people, I am having trouble starting my '02 fs650. I've tried all in the hard start guide and all seems to tie up. I have the fuel/air mixture screw 1 1/2 out and it tried to fire! but the only way I could get it to pick so it would tickover is to increase the ticker over until it fired...

Hey! Does anyone know what the Duration and lift and timings on in lobe and ex lobe is for the 08 cam stock in 650 -05? Anyone tested to change stock timings anyting? Thx in advance

Stock exhaust, 91 octane pump gas, larger pilot jet supplied by Husaberg. Max 53.1 HP Max 40.0 SAE Torque Someday I'll get around to trying an aftermarket exhaust and see what happens. Still got lotsa oomph for now.

I need to know what the stock WP forks are on my 1998 FX600. Fork Size: 48mm ?? 49mm ?? Spring Rate: 4.2 ?? I'm really not sure and I need to know in order to investigate purchasing some parts such as seals, boots, springs, etc.. Also, I am looking at purchasing an additional Berg...

I had been given some advice (by a local dealer) not to ride my FE650 on the highway for long periods of time because the engine would overheat. Does anyone have any experience in this department? The longest I'd be going for is about an hour and 1/4, at an average between 70kph and 120kph...