start

Husaberg

Help Support Husaberg:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. L

    2010 Berg fe450 troublesome start

    Hi everyone, I have a FE450 and just wondering if anyone has had a similar issue as me. Rode the bike on Wednesday with no problems. Just went to start it now to go for a ride. It has no spark and can’t hear the pump prime either. All fuses are good. Battery was a little bit flat would this...
  2. agcmanowarrior

    FE400e 2002 doesn't start at all

    Hi guys, I recently changed my SEM with a new stator because my SEM basically died and motorcycle stopped working. After installing the new replacement stator the bike doesn't even give a signal on any kick start move. I'm starting to get desperate and my love for HusaberG to fade away, so...
  3. D

    Start fail , when hot engine fe450

    Hi I have a problem with My husaberg fe450 2010. When they motor is hot it have problems to start . O clean inyector change filters they pump run and give 3,5bar of pressure, check de wire...... Some idea? Thanks sorry for my Bad English
  4. A

    2008 FE550 hot start

    Not sure if mechanical or other tech, but how do you hot start your FE550? I was caught out yesterday, stalled my Husa, quickly emptied the battery trying to restart electrically and then myself trying to kicking-start.:eek: Only after a 30min cooldown could I get it to run. I tried to mess...
  5. G

    Electric Start issues again

    Hello everyone. Hope some one can shed some light on the following . I have a 2003 Fe501, It will start ok kick starting. But im getting old ,so after about the fourth get off per day I would like to be able to start on the button, So the mods I've made so far are R6 Starter motor. New...
  6. S

    Husaberg FE 570 - Bike won’t start

    Hey folks- I could use some help. My FE 570 was behaving oddly during last few rides: stalling out while under throttle, most of the time a quick press on the start button got it running again, sometime I had to wait awhile. Then it stalled out completely during my last ride; bike would not...
  7. V

    Can I tow my Husa 450 to start on cold weather ?

    Can I damage some internal parts of gearbox if i tow my husa to start it on 2-3 gear in the cold weather? I am lazy to heat the engine block and start it by kick,easy for me to ask my whife to tow me for start it in the gear then go for fun...
  8. V

    2004 FE450 E-start low crank and no start

    I fixed the hot start for my FE450 using the valve adjusments as 0.6 turn . very easy kickstart now, event not necessary to use the decomp when hot. But the Estart not work. Accu is just new , Exide AGM 110 A , i have 2 tried electric startes mitsuba in perfect state . Starter turn...
  9. A

    Mother of all non start mysteries

    Hello Fellow Husaberg people. Thanks in advance to you all for all the great information I've so far used to work on my 2009 FE 570 My problem: My bike wont start, sometimes it will if i crank it over for 30 seconds or more it will backfire and eventually start. it was running ok (a bit...
  10. R

    no start

    Hi everyone , this is my first post. My friend has a 99 FE 400 non electric start, he brought it to my shop, said he had to pull it to start bike, I checked the valve adjustment thought one was tight, all set at .10mm, checked cylinder leak down all good. I went to ignition test have no spark...
  11. F

    2009 FE450 slow winding over ? no start

    HI I own a 2009 Fe450 - it will not start off the Estart - I used to but now no good - can drop stop it fine - have checked the decomp and its seem to be working fine - valve clearances are inlet 0.11mm / exhaust 0.14mm - have put brand new battery in it (170CCA) - no change ? - have tried...
  12. Shanuss

    electric start conversion

    2003 470. what would i need to do to as electric start to my bike? is it worth the cost? how much would it cost?
  13. C

    FE250 Cold Start Issue

    Hey all — new to the forum. I have a 2013 FE250 that has had starting issues since I got it. I basically have to pull the idle button out and turn the idle all the way up for it to start. And once it does start up it boggs until the engine is fully warm (1-2 mins on a fast idle). I've not...
  14. FraserThompsom

    FE650 Wiring Loom (Kick Start Only)

    Hi Guys, I have just bought my first Husaberg and its a 2002 FE650 but it is kick start only. I have a base knowledge about Husabergs and lightly know my way around a bike. It is kick start only and has no Battery, ECU, starter motor etc but I believe it has a rectifier. I'm just...
  15. FraserThompsom

    How do I start a normal thread?!?

    .
  16. V

    fe 390 wont start

    hello everybody i got my fe 390 1 year ago and all was well. about 3 months ago there were times when the bike wouldnt start when cold. it does this once in a while i cant figure out what it is. changed the battery and spark plug but i reckon its either electrical or fuel. i would appreciare...
  17. V

    fe 390 wont start

    hello everybody i got my fe 390 1 year ago and all was well. about 3 months ago there were times when the bike wouldnt start when cold. it does this once in a while i cant figure out what it is. changed the battery and spark plug but i reckon its either electrical or fuel. i would appreciare...
  18. E

    2011 FX 450 No Start.

    Having issues getting this bike running. Turning over but just pops once in a while. ive put a V/O meter and tested just about everything. -injector was taken out sent in cleaned and flow tested -fuel pump meters out at around 50psi and can also see fuel spray while cranking -pulser...
  19. A

    Help! FS570 2011 wont start!

    Just replaced the fuel pump on my 11’ FS570, and it still won’t start. No noise from the pump [emoji20] FI Code is 4x long 1xshort, which says fuel pump relay. Now i have checked all the fuses under the seat, but does anyone have any tips? Where is the relay located, and any other useful...
  20. 1

    No start after tip over ?

    Hey All, Had a tip over then bike would not start. Got it home and replaced pump with Cacycle pump but still no or very low fuel pressure . I am showing about 1 bar or 14 psi while cranking and then pressure falls to zero. It appears to be pressure regulator bleeding down not holding pressure...
Back
Top