stalling

Have an 11 fe 390 with the full fmf exhaust, the dealer has giving me the lastest mapping after i complained about a stalling issue on the trails when the bike gets hot. it still stalls ! but starts right up. any one have the fix?

I bought a brand new 2011 390 FE and first day riding hour 2 the bike kept stalling out and would not start right away, had to wait 5 to 10 minutes each time to get in running, note I installed a electric fan and put in a pro filter so no dirt gets in the tank. I did hear the coolant boiling in...

I'm almost reaching the end of my rope with this stalling issue. Once the bike is hot it will stall at low rpm's, must of stalled 20 times on me yesterday. Things I have tried/checked: currently at comp map ending in 1002 new plug new plug cap wrapped mid pipe dealer changed fuel...

My first Berg love it. Only quirk so far, if I stall it say why rolling I can not just pull in clutch neutral, whatever, and start it. Roll to stop then hit starter it acts like battery is low. So far I shut off key reboot so to speak. Then it will start. Any thoughts, does this sound typical...

I wnet back to my dealer to verify I had the latest map after a lot of stalling on my first ride. I didn't write the exact map number down...I should have... Mark Donovan had mentioned the latest map is "1001" looking at my map on the dealers computer it did contain "1001" in the middle...

I think i have a fuel issue, have brand new 390 2011, however if i aggresively open the throttle the bike stalls, is fine when i feather open the throttle, Please advise

my 09 450 has done 160 hours, I did all the nessecary work almost exactly as rhe manual says. now, after 30 -45 mins of riding all sorts of trails, the engine wants to stop for no reason, although it occus when i pull the throttle qoute firmly. It feels as if the carb is giving problems, but...

I have a 2010 FE390 theres 11hours on it and i got the ecu flashed. Its always had problem starting i would have to give it a little gas for it to turn over even that wont always get it started. My buddy has a 09 FE450 and that thing starts no problem you just press the starter. 1 second later...

Bikes acting weird, starts good, when driving it from cold I can drive it for about 5km then it starts violently shutting off. I keep the throttle open and it goes full blast for two seconds, then nothing, .... When I stop and restart it (immediately) it starts ok and I can go again for a...

Hi all, annoying problem with my 650 advise appreciated. Lets say I'm sat at traffic lights and it's been ticking over for 20 seconds or more, when I slowly open the throttle to pull away sometimes it stalls. If I were to rev it quick then it may just bog slightly then pick up. Have played with...

I have 2 problems which I think relate to the same thing: 1. Really hard to start on hot. Cold: 1-2 kicks. 2. Stalls when slightly opening the throttle from idle. I'm a beginner mechanic not very experienced with bikes so I try to explain everything step by step. FE 400 2002 had 17...

Sometimes my engine (501 / 03) stalls when opening the throttle from low revs. When the revs are a little bit higher there is no hesitation at all. This is fairly new, I never changed anything on the carb settings; simply because I had no reason to do so. What do you guy's recon? It always...

Hi guys, I've looked throught the doc and other postings, found two similar issue, but neither suggestion fixed my problem... The bike starts great, and runs fine until it gets very hot (slow riding in heavy mud etc.). It then starts to die on me when opening the throttle from idle or...

First of all hello folks this will be my first post here. I had a curious problem with a 450 enduro bike. Once warm it would stall from idle if you tried to accel suddenly. One or two little blips and it would not pick up, just chuck it. Easy opening of the throttle would not cause this. It...

I have a 2002 E-Start 501. Until recently, the starter motor has disengaged and free-wheeled after cranking several turns. Since it has always been an easy starter, that has not been a problem. Recently, it has refused to start cold ( ambient temp of 70F ) or hot with the magic buttton. It...