spring

I can trade also as i have a 8.4 and a 76/95 that has two hours on it and it looks like new. The 8.4 is very good as well but has about 20 hours. Thanks

Folks, is anybody having an idea how to tell the 4.2N/mm fork springs (2004s) from 4.4N/mm ones?? Thanks TheEngineer

i am trying to remove the rear spring and replace with a new one

Upon removing the head cover on my 01 470 Fx today and inspecting the autodecompression device I found it to be nonfunctional. So maybe thats why this particular 01 model would never e-start. The spring loaded device is supposed to remain in this position (I think), which is on or open and...

This was sent to me from Husaberg. Other handwriting is mine.

Hi guys! I'm looking for the recommended spring rates for the 04' FS650. Stock is: front 4.4 Nm/mm, rear 84 Nm/mm. I'm +95kg's with gear. Does anyone have the recommended spring rates laying around? The partslist only gives a couple of suggestions, one step harder or one step softer. I'm...

I'm helping a friend set up his 'berg. It's a 2000 501 that he's using in the woods. He weighs 220#, 240# w/gear. Currently has stock ?? springs up front and a PDS-2 in the rear. Choosing the fork springs should be no problem, but... 1. Anyone know the stock fork spring rate? 2...

Managed to snap the bottom off of the exhaust valve spring. Have any of you guys heard of this happening before? I couldn't get any warranty on it because they reckon I've overreved it, which I didn't but anyway that's what I thought a rev limiter was for? Luckily the valve didn't drop...

Sorry this ain't exactly Husaberg, but does anyone (preferably in Oz but shipping may be an option) happen to have a spare gear lever return spring to suit a '96 TE Husqvarna that they would be prepared to sell? They are probably the same from '92 onwards. I can't go too far 'cause my mate's...

I have just recently bought a 2002 650FE, I am still trying to sort it out. I have a 01 520mxc I run a pds 4 and .46 up front w35mm static sag front and rear. I was wondering if I should run the same on my new/used berg. I weigh 205lbs in street clothes, and I am an expert-level rider. The berg...

Thor's Hammer swings in my direction again. An intake valve spring broke at 347.4 hours. Fortunately the engine was only at about 3500 rpm and it quit quickly. The damage was limited to 1 bent valve, broken spring (3 pieces) damaged spring retainer, and valve keeper, and a bent 2003 rocker arm...

Does anyone know what weight fork springs were stock on a 2001 Fe400e?

I just picked up a new 03 fe400e and the throttle return spring is much lighter than my 02FX470E Throttle return spring Id like my 400's throttle to have the same feeling as my 470's can these springs be interchanged?I looked at the parts manual and they only have one part number for all the...

Anybody know the spring rates for the forks of the 02Fx470E? The rear is a PDS-7 76-95/260 I will be upgrading soon. My Fx470 front end dives bad when under hard load in the conner's and my suspension tuner feels I needed larger spring's front & back? Front he wants me to go with a 4.8 and in...

hi; i checked the sag as per the manual and i'm way out of spec. it's 50mm when it should be 5-20mm. what is the procedure to adjust this pre-load? thanks tuts