sensor

I had an issue last week. I dropped my 2011 fe 390 on its side. Nothing hard. The tip over sensor tripped, the bike turned off. I picked up bike, started it, and off i went, for another 30 seconds anyway. The bike started to sound rough and more jolty when I gave it gas. Then it stalled as if I...

I have a 2011 FS 570 with only 22 hours and the flash code is blinking one long, 3 short: air intake temp sensor. I have never removed the gas tank. Any ideas? Help? The nearest Husaberg dealer is far far away..... Thanks!!!

Does anyone know what the procedure is for resetting the rollover sensor after you have laid the bike over? Mine is a USA 2011 FE 570 S. Every time I lay it down, I can't get it re-started. I have read enough to come to the conclusion that it is the rollover sensor preventing it from starting...

Hi guys Just retro fitting my low fuel sensor kit to my 09 fe570 does the sensor have an o ring that goes in the recess on the sensor to seal against the tank or some kind of gasket. Mine didnt come with one and wasnt sure if it needs one before cutting an installing into the tank ? Thanks...

Where is my Lambda/O2 sensor? The manual shows the sensor near the spark plug in the second section of the exhaust pipe. Thanks, Todd

I looked high and low but cannot find a test method and spec. I can assume it is a resistance test, but how many ohms under wet and dry condition? Mine tests out at ~825,000ohms, wet or dry, at connector and at the device itself, so I'm pretty sure it's a dead duck. FYI: The shrink-tubing on...

Hi can you get replacment speedo sensor pickups on a 2003,av made a bracket up to hold a bigger caliper on a supermoto setup,with a ktm 310 disc then a mate snapped the fuxking end off the sensor. :cuss:

I bought this six piston caliper two seasons ago. When I bought it, I failed tp realize that I needed a different fork setup. So I ended up replacing the Husa FS forks for a set of dirt forks from a 08 KTM SXf450. Now the brakes bolt up and work VERY well. Only I ended upgoing the whole last...

Soo. Got my self some supermoto front dampers with radial mount to the caliper, and bought a Magura radial caliper. Big question, how is the speed sensor mounted on the FS570 ? -Can i use ktm part no : 76514068000 ? If so, do i need anything else ?

I Have my new 2011 berg 390 EU from Austria and I am swapping the OEM header for a FMF megabomb.. This new megabomb does not have the option for putting the lambda sensor, I installed my new header and turned the bike on and now the FI is giving me an error code with 4 long flashes and 5 short...

Hi! Doesn anyone know how the coolant temp sensor "works"? Temperature / Resistance (curve) ? :) Thanks! Regards

Hi there, there is a GAS-LEVEL SENSOR on the back of the fuel tank of FE450. Mine is broken (brown wire damaged). I have ordered a new one (PN is 58207080100, it is a KTM part), but electric plug does not match with the cable coming from the EFI block. 1) did anyone replace the GAS LEVEL...

What are you guys doing with the Oxygen Sensor when you install a new exhaust on a 2009 FE 570? I know it is not used and really does nothing but just wondering what to do with it? Zip Tie it to something or just cut it off or ??? Thank you.

I went to pick up my bike today from my dealer and got halfway home before the FI light started flashing at me. Turned around and took bike back to dealer. One long, two short - coolant sensor. Flash code FI warning 12 FI warning lamp (MIL) flashes 1x long, 2x short lamp (MIL) Input signal...

Can you remove the roll over sensor, and bypass it soyou do not get the error light?? Mine was destroyed in the fire, and if I can do without it, it will save me some $$ in my rebuild

Did anyone ever figure out a way to discconect the rollover switch and get rid of the blinking light?? My sensor was destroyed when my bike got burnt, and I can do without spending the $100.00 to replace it, if I don't need it

I have read a number of places and heard from a few sources that the oxygen sensor in the header pipe is not used for any purpose in the USA '09 model year FE 570 bikes. Can it just be removed and replaced with a flush plug? Or does it actually serve a purpose? If not, why is it there? Getting...

The green female end of my my water temp sensor came off and melted on the header pipe. This connection is just to the left of the spark plug on the right side of the motor. The clip has a stamp with "AMP 10737 11082" on it and is part of the wiring harness of the bike, so I can't buy just the...

After driving to Washington to enter a 100 mile desert race my bike got scared and decided not to start. They had a poker run on Saturday that I went on. Half way thru I stopped to check a downed rider. After that she wouldn't start and killed the battery. I just installed an 8 cell lithium...

does anyone know what the thread pitch is on this? I would like to plug it,and then cover everything with some DEI pipe wrap.