sensor

Hi so as the title descibes, my fe570 has sometimes the power it should have, mostly when its colder outside and sometimes it feels like it has 10hp less. It can even be felt when im riding and enter a forest where it is cooler the bike suddenly wakes up. The engine is in perfect condition, i...

I recently bought a 2011 FE 570 EU-model and am trying to find out why it's CO value is quite high. I don't know if it still has the original mapping on it. I tried to check the lambda sensor but I'm getting a strange result. I did bridge two pins in the diagnostic plug before the battery so...

Installed O2 sensor to exhaust but i dont know what are the best AFR values at some RPMs for this bike? Anybody have some info?

Would anyone have a TPS sensor off a fcr carb for a 04 450fe just seeing if anyone on here has one that they would be willing to sell and mail it to me in Ontario Canada. Mine currently have a short in the black ground wire on the TPS right where the wires go into the plastic on the carb so I...

Hi everyone I have 2009 fe 570 that came originally with no gas level sensor.I changed the color of the tank and now i don't see gas in the tank.I got the GAS-LEVEL SENSOR 58207080100 but it came with no wires.(i tried to find HARNESS LOW FUEL INDICATOR (nr: 81211091000)but is no longer...

Fi light flashing now and then... comes on when riding bike will almost quit but clears it self up. When it dose it at start up it won't start but wait 10 seconds and try it again it starts. Checked the harness all looks ok. Would this be a sensor or is the crank moving giving me an air gap to...

hi all, ive got the vapour computer fitted to my 2002 fs650. i noticed there are 3 wires hanging out. I've looked into them more and have ended up buying a power lead and the coolant sensor my question is where is the best place to locate the coolant sensor? it invloves cutting one of my...

For those with 70 degree Bergs, I'm trying to figure out how the street legal bikes with rear brake banjo bolt sensor have their wire routed to the taillight? My bike is a FE570 with FMF full exhaust and that pipe is very tight in that area near the rear master cylinder that I'm not sure how...

Just picked up a '10 FE570 that has a full Ti exhaust. I found the O2 sensor covered with a rubber plug and taped up zip tied to the front frame rail Obviously with no bung for it in the Ti FMF exhaust they had to do something. But should I do something else with it... Like remove it...

Hi there. I have a 2014 FE250. The crankshaft position sensor has failed catastrophically twice now. Once at 200 miles, and again at 400 miles. When it fails, I mean really fails... copper wires broken and spilling out of the sensor. Has anyone else experienced this type of failure...

2011 FX450 Can anyone tell Me about the crank position sensor. Mine might be bad? Bike has spark , compression , fuel pressure good , fuel injector working good cleaned it and checked spray pattern also good. Bike will not start? Doesn't even run bad? No flashing lights. Help

Hi Guys, 2012 fe450 stopped and will not start again, winds over, got spark etc... I noticed fair bit of oil in filter box, could it be the sensor in the air box the reason it will not start..mate said its most likely cause?. Rode the bike pretty hard for 100kms then stopped dead on rough...

Hi. I have a husaberg fs450e 06. Ofcourse the speed sensor cable and the magnet are missing. Where can i buy this? Maby someone ships too norway? I didnt find anything on ebay, only for vapor. The speedo works when the wheel is turning? Correct? When i push one off the buttons it starts but...

Oxygen O2 Sensor Eliminator Husaberg FE 570 09 ON | eBay Has somebody already tested this? Is it worth it? thanks for feedback

Here is the problem. My '09 FE450 runs great for about a hour or maybe two. Then it starts to hesitate and sputter randomly. If the bike cools off, it runs great again, so it appears I have a heat soak problem. It is not the gasoline overheating since refilling the tank with fresh, cool gas does...

Anyone ever experienced the following: My bike takes a couple of minutes to start after being tipped over. I feel that the seal in the fuel pump may be failing.... After letting it stand on level ground for about 2 minutes the bike will restart. the pump is running when i attempt to start the...

Good afternoon I'm Thailand and just has one 570.. 2010.. I'm new for Husaberg First . I would like to know about "Rollover sensor "main function second : and consequence with ECU or function to ECU and can we reset it or can by...

Hi Taffy can you supply a new speed sensor, part no 583.14.069.251 i think. Can't seem to find one online anywhere. Mine has snapped at the thread and is intermittant. Hope you can help Carl

My husa stalls sometimes as landing stopies. wondering if this roll over sensor located under the batterie housing could not be the cause. and if their is any way to bypass that without affecting fi warning light. at first , same probleme occured as oil from head cover vent filled intake with a...

Hi I have just bought a trailtech Vapor speedo kit, I was just wondering what side you would recommend installing the temp sensor for the radiator, I have read people placing it on the left side and also the right. I have also bought a radiator fan kit and was wondering if that would interfear...