screen

Hello everyone, have any of you ever seen anything like this? I bought a FE 390 2010 where the engine was supposedly rebuilt a few hours ago. Corresponding receipts are included. During the first oil change, I found the oil strainer like this... It looks like small pieces of...

Ok hi guys, I did an oil change on my burg it's a fe 450 and i pulled the screen out of the banjo bolt at the top of the engine and now can't remember which way it goes in. The screen is only open one end. Cheers in advance. Sent from my SM-G930F using Tapatalk

hello! The oil screen on my husaberg fe 400 2000 is impossible to pull out. Any ideas? I dont want to split the cases again. another question, is there any possibility that coolant is leaking from inbetween cylinder and cases? are there any coolant circulating below the cylinder? or is the...

having just bought husaberg 650 supermoto i was doing oil change has anyone had difficulty removing oil screen plug im finding it near impossible to remove any ideas would be appreciated

Hi guys, Just trying to do an oil change on my Fs570 and the oil screen plug bolt is stuck..is this a reverse thread or something? it shouldnt be this hard to remove..ive been trying to turn it anti-clockwise to remove it. HELP PLZ!! :o

Hello, had anyone a simular problem with an blocked oil screen? I refreshed an FE 570 engine due to damaged big-end,also the cilinder and piston got damaged. So this was an expensive operation! Before the big-end went out my friend rode 2 hrs without cooling water in an enduro race, so it got...

I have neglected to note which way to insert the oil screen. The outside diameter is the same but the inside is different on each end. So can anyone tell me which to insert into the engine ? bigger or smaller ? thanks

Just started getting a few non Magnectic flakes on the oil screen. Can anyone tell where these could be from ?? And should i start panicking. FE400 e/s 2002. Cheers Bob.

2006 FS 650C Engine has 46 hours and 1706 miles... I changed the oil about 2 hours ago and all was clean... I noticed my base gasket was starting to leak, so I just decided to drain the oil for the hell of it... I found some small flakes on the screen... Any cause for alarm, and is the...

Just a question, does any debris gather on the inside (my guess is yes) or outside of that screen? I just did my first oil change and had a look, no debris on either side, so I just put her back in. (Just a minor amount of flakage on the lower screen too.) Thanks.

so, a month left in my riding season i fixed(actually failed to fix) an oil leak coming from the clutch side case just above the oil fill plug. I went to go order the new gasket and figured i couldn't wait while they had to order one into my country. Anyway, i used a gasket sealant for a temp...

I have a 2001 fe650. When I pulled the drain plug, I found there was no oil screen. Was this present on all 2001 models? Do I need the screen if I have a magnetic plug? Thanks in advance

Hi all, it seems my screw-in screen cap rattled off on me and wondering if someone might have a source where to get a replacement cheap or maybe someone is willing to part with an extra one? I don't see a spark arrestor beyond that, so is that it? Thanks. Mark

Doing my first oil change and i have taken the banjo bolt out and screen out of the oil line othat go into the head. After pulling it apart and cleaning it i noticed that one end of the screen is closed and the other is open.. Now I am not sure which way to install the screen, open end into the...

I just picked up a 2010 FE450 and I am in the process of adding accessories and getting ready for spring. I have read mixed opinions about removing the screen on the end of the silencer. As I understand it, the 2010 has an internal spark arrester, so I don't need the screen for that. I have...

hey hey im just doing oil change and i have dumped oil then clean oil screen now i cant remember which way it goes in, each end has a different opening size? does anyone know? thanks guys

Does everyone take the perforated screen out of the end of the silencer? I'm sure it keeps the sound down but it sounds like a running a leaf blower through a straw.

2008 FE550, 17 hrs, third oil change, ( changed oil at 3, 8 and now at 17 hrs) using Motul 300V 15W50. Found some bronze bits on the oil screen, should I be worried about this or is this normal bit shedding on an Berg engine thats running in?? I've included a pic of the debris. Ed...

Should I worry about this? They are not magnetic so its alu.. about 15 to 20 very small particles sorry for the blurry pics

When changing the oil in my fe650 04 today the oil screen was covered/full of silicon. Had the transmission and waterpump covers off 5h ago and used the old gaskets together with blue silicon (apparently too much). Question is if any damage has been done to the engine. Looked at the oil...