quick

Hei guys. I changed my fuel pump and completely destroyed the quick connect, the in tank one with the four or five little tabs on. Have tried to find a part number, but van only find kits with either fuel pump or pressure regulator included. Do anyone know if this are possible to order, or if...

Just sorted clearances on my berg (04 fe450) noticed plug looks a little lean if anything from what i know anyway ? Was just going to turn mixture screw a tad in the right direction, can't remember which say though lol, take a look at pic and see what you think, maybe I'm being too fussy

Hi all, I've acquired a 2005 FE450 in large lumps, seems mostly good. Think it was taken apart pretty much for a clean and service before the last owner lost interest. Plan is to assemble it, do just one enduro and then strip/rebuild the engine fully over the winter. The engine oil wasn't...

So, going in again to change the pump seal and have a question about how deep to send it into the cover. Do I need to only drive the seal until it's flush with the cover, or until it seats against the oil seal? Last time I did this, via 3 seals later, I managed to seat the seal flush with...

Hello all, I bought a used FE570 and I found a bit on the bike that looks a bit strange to me. Just beneath the tank is a fuel filter covered in aluminium foil to reflect heat. The place for this filter is just weird (above cylinder), seems to me that this would not be ideal for the fuel, to...

Hi Guys. I have a husaberg Fe 501 2004. Just wondered what oil to use in my bike. Is synthetic better than semi synthetic? Thanks in advance.

hello, there are many makers and some type models like circular sensorr,lever+sensor. which one do you ve install? ;)

Just got my FS shock back from servicing, and removing the spacer. It's full length now, like my FE forks. I searched and can't find an answer. I want to rotate the bottom of the shock and install it so that I can adjust the rebound easily-er...from the left side. My chain slider is...

I already have one, but this sounds like a great chance to get a 2011 FS570 in the Bay Area. 2011 Husaberg FS570 Race Supermoto - low miles/hours

I have gone through hell and back trying to get my '09 FE450 to run. Turns out it was a bad replacement fuel pump. I am posting this to as a quick 5 minute way of finding a bad pump, perhaps saving some poor soul the aggravation I went through. Simply remove the fuel line from the fitting at...

Hey just had to drill, tap and helicoil my water pump cover threads and in the process drained the oil. Forgot that bergs use a 10w50 n put in a 10w40. For a days riding will this have any effect ?!

Does anyone offer a quick release skid plate. As the stock '11' is held on with one bolt and the rear hooks over the rear lower frame cross member I consider it to be quick release. I'd like one like this that has wider ears towards the front. Anyone make one???? Thanks !

Hey guys would you happen to know what size nut the rear spindle nut on a 2010 husaberg fx450 is? I'm assuming they are the same 09-11 on all models but I can't find the size and i'm heading to the store I think it may be a 26mm. Thanks for the answer in advance :)

Hi guys, The fuel line quick connect fitting on my Berg, has the release button/lever facing inwards. This makes it very difficult for me to get at. Especially with the Cam adjuster in the way. Maybe I am just being ham fisted, but I really need two hands two clip it back together, and there is...

Hi Guys, I'm going to set the valves on my new-to-me 2008 FE 450. I've done BMW adjustor type valves but never a dirt bike with a decompression lever. Do I disconnect the spring or lever prior to checking and adjusting exhaust valves? Then when valves set ok reconnect and adjust cable free...

Hi There, Thought I should post up a quick hello and introduce myself. Name: Scuba Live: Melbourne, Australia Married, kids bla bla bla non-important stuff Bikes: 09 KLX140L, 08 Kwaka KLX450R, 08 KTM EXC250F, 06 Husky WR250, 05 KLX125 and new to me an 06 Berg FE 450 The Berg belonged...

Have searched through the old posts but have found nothing about this other than to buy a complete throttle. Saw a post somewhere about a R1 rider doing it so I thought I'd give it a go . Just pull the throttle apart and glue two zip ties one on top of the other around the throttle cam and...

A few questions have been bugging me and i just wanted a few quick answers if you can guys: [all relate to my 53 plate fs650] 1) are there any 2 finger levers on the market ? i only use 2 fingers for braking and think 2 finger clutch lever would make life easier ? 2) Can i fit a 160 rear...

Hi! My bike has shown an issue, and I don't think it's been there before... Today at the mx track it felt like it almost died when I blipped the throttle, and if I went to WOT sharpishly from idle it was just as effective as hitting the kill switch. I thought it was water in the carb...

Did a re-grease & check on my head stem bearings a week or so ago, managed to hold the forks and pack grease into the bottom bearings and do the top bearing / whack a bit of extra grease into the head yube for good measure, so didnt actually remove the whole box and dice. once I had it back...