questions

I could use an early FE501 schematic to finish wiring my bike. The PO had removed most wires and kept a bare minimum like a MX bike. Meanwhile I have some questions: 1) on the 95's ignition module, there is one wire that is a mystery. The red one. Is that a power-on wire or is it a shut-down...

Hello I am new to the forum and thinking about purchasing a 2011 FE 570 for touring around the world. In order to pick the right platform i am interested in maintenance on the bike, underlying issues concerning the 2011 model and what would or should be changed/modified on the bike. I pack...

Hi all, greetings from Hungary! I ve just bought my first Husie, a 04' Fe550, so im fresh in this community. Skid

Hi all, Since today I am a proud owner of a Husaberg FE 390. The bike looks mint and can’t wait to take it out, absolute love it! Besides my Husaberg I ride a Montesa Cota 315r trails bike. IMO they make a nice match :D I will post some pictures when the rain has disappeared and look forward to...

Hello everyone , hope you are doing well. About two months ago i bought a 2007 husaberg FS 650 E , in good condition at a seemingly good price . Not gonna lie to anyone , it was my teenage dream this bike so i'm pretty stoked. The bike was in good nick over all , no accidents or damage...

Hi all new to this forum my name is Lee from Cheltenham uk! I’ve recently got myself a 2003? Fe 400 and have a few questions I would like to ask! Q1 I’m a little confused on what year the bike actually is? Engine and frame numbers match with logbook the frame No is YU7FE4E8430000098 which...

Hello all, I recently bought broken Fe650 2004 with restoration in mind. Unfortunatelly, there are some issues, I think, that motor is not from this bike. VIN says VBKHUA4014M773550 numbers on the motor are: 4011172 and has SEM inginition, no e-starter Any hints? Was it swapped from Fe400?

I have a 2011 model 570 and i am after a new seat cover, the one on ebay says its for a 2009-10 model. Is there any difference in the seats over the years or will it fit anyways? Thanks

Hi guys picked up an 02 fs650 and have a few questions to ask. I have adjusted valve clearences changed oil and filter used motul v300 10w40. And gave everything a once over. The clutch needs pulled right back and even when it is the bike still wants to pull. It was also doing this before the...

new to posting thread so sorry if I'm in the wrong section. I recently purchased a 2011 FE390,love the bike, but was thinking of running hare scrambles was debating on a steering damper, recluse clutch and ECU map. Does anyone have experience with any of these mods? worth it? any suggestions...

Hi I just bought a 2014 TE 300. I noticed that it doesn’t have a map switch- was this a standard feature or not? Also I read somewhere that the vforce reeds were standard but my bike doesn’t have the vforce label on the reeds block. Please could someone confirm whether the above were...

Hello all. Very happy owner of a 2008 FE650 here. Firstly I'm sure most of these questions have been asked before but if you dont mind I'd like to post them here. The inevitable oil breather. Is it normal for some oil to be in the airbox ? I have the stock Y piece later design breather but...

So I just picked up an 11 FE390. Seemed like a bought it from a good guy, very cool to talked to, had a quite a few nice bikes, and while he didnt keep everything spotless like I try too, he seemed to have kept up on all the service work. Well it was around 20 degrees when i got there, bike...

Looking Under the seat, and under the headlight there is too USB cables. Under the seat is a male connector, and under the headlight a female connector both are the same colored cords so I'm assuming they connect together. Could anyone give me some insight as to what these are for (pictured...

With no history on the bike except that it's a bit hard to start and with an upcoming tear down/status check I have the following questions: 1. I have read here that the cam follower bearings often go bad and should be replaced periodically. Is it enough to inspect them or should they be...

G-day guys, so my battery is knackered, and am looking at new ones and was wondering if the higher cca of the 6 or 7ah is a safe option for bike or will it make my stator work to hard? I mean the stock battery with its 40cca seems on paper at least to be pretty poor… Next question how many...

Hey guys i recently bought a low mileage 08, There are a few mods i am wanting to do to it and was going to do all the electronic ones at the same time. so i have a few question. One how powerful is my stator? I was wanting to add a charge port or two… for phone and GPS will it handle this? If...

Hi all, I have had the bike for a couple of months and put about 10hrs in so far. A few questions have been collecting on my mind ... 1) I have noticed that my bike, is harder to start when hot .... it could be my, I am suspect, original battery not being able to hold a full charge or you...

Hey guys, Just bought my first Husaberg. Its a 2007 FS650E. This thing is a blast and I cant wait to take it with me next time I head to the track. Couple quick questions. I am assuming the 07 FS650E is virtually the same as the FS650E's manufactured in a few other years. Any idea what...

So, I want to get everything ready on my Berg for next season. And I have a few questions. I got my valves checked last year because of the hard starts and noise I was getting. The valves were all perfect but they replaced some spring they said was the cause of the noise. However, the noise...