oil

Hi can someone tell me if there will be some kind of oil seal behind my front sprocket. At first i thought my chain was over lubed but it seems to have oil coming from around that area.... Any help appreciated.

hi all.did a service on my fe570 today, removed the strainer on the return line above the header pipe, cleaned it, without taking notice what direction it was in there.logic tells me it should go with open end of the strainer exposed the and the closed end into the "banjo bolt". could someone...

Hi Everyone. Just recently bought a 2009 450. It was running smooth as the first few days but in the morning i noticed some oil drips. looks like it was coming from the crank cover? is this an easy fix or a big problem?

I had the problem with the weeping hole recently and a spring on gear selector so bike had been apart. Fixed both the problems, got a gasket cut for clutch side casing as nobody around me could order one in for the same week. Put the bike all together filled up with oil, no problems. However...

Earlier this year I replaced the paper filter with a stainless steel one. One simple question for any one else that's running one,.. How the hell do you remove it? With the paper filter I would just use a magnet, but that trick doesn't work with the SS. Freaking thing is impossible to...

Can anyone confirm whether this is simple it not? For a Berg/KTM 2013 450. Is it a case of drain oil and replace? Do I need to lie bike on side? Or is it harder and require more parts to be removed? Anything I need to be careful about?

Hi all was reading that my engine does not have a proper oil pump can any one explain how it works as it sounds like bad thing lol don't quote me but I think I read some were it has a Reid oil system :)

Attached is a pic of an oil leak that is coming from a bolt that I believe is one of the oil drain plugs. The photo perspective is from the underside of the bike, bash plate removed, from the back looking forward from the right side. These are on the bottom rear of the engine block. To the right...

Hi all, My 04 fs650e is showing me the signs of a serious failure (or something much more simple) and I'm hoping someone can shed some light on it before I go in blind. The last oil drop (350ks) has shown a heaps of small, square, shiny metallic, non-magnetic flakes. They are too small to...

Hello, Emptied oil yesterday before pulling left side case off. Tons of metallic flakes in the oil. The magnetic tip on the drain plug was completely covered, and more just suspended in the old oil. I cleaned the oil screen and it too was covered. The two largest pieces I found were about 3mm...

I've got a leak ! 04 550 when I get back to the garage there's oil on the floor it's dripping from the tab on the bottom of the flywheel caseing .. please don't tell me crank seals as they just been done ?

I have a oil cooler kit basically ready to bolt on, including cooler, lines, filter cover tapped for line, and a tappet cover, intended to be tapped for a line. Has anyone here actually done this install? Not sure of how to finish it. I think I need a restrict or to limit flow as well as a one...

Hello guys. There is a seal under the bearing which number is "0625 062013". It was not seems on part diagram. So where can i buy this seal? It seems it is a special seal and i can not find it anywhere. Thanks.

Hi I recently bought a husaberg 350fe 1993 And I want to change engine oil before driving, So I wonder witch engine oil should I buy? Thanks for reply! Sorry if the English is bad ! I'm from Sweden, But I hope I made me understand :)

Hi all I have just got my bike back from a Valve check and the mech said I had too much oil in the bike. (2010 fe450) I have just drained the oil out completely and measured the oil back in as its only two rides old. The Manual says to check oil with bike cold and standing straight. I have put...

I have a 2011 FE 570S. I lost the clutch action recently and discovered that the oil level was low in the reservoir. I have refilled it about three or four times, but cannot figure out where the leak is. I'm not picking up much dust on the reservoir.The cap rubber looks intact. Today I pulled...

Hi all I have a very slow oil leak from my gear selector shaft, where it pops out from the left side engine case. As far as I know its a simple o-ring fix and most bergs do it to a certain degree anyway, but mine is beginning to get worse. Im going to tackle it before it completely lets go...

Im trying to get the fork oil level and procedure for my 11' FS570 front forks. they are a WP-USD Ø 48 mm Closed Cartridqe. I had to replace the cap on one side so I'm not sure what to do to make sure I have it setup right I tried getting the manual from my dealer but they only have it on...

Hi. I need your help. I have Husaberg FE550e 2008. I want to ask how much oil I have to pour in to fork WP USD 4860 MA in ml. My weight 72kg. I can't find manual anywhere. Please send me manual if you have.

Could anybody tell me how much and what weight oil for a 02 650. Could you guys also confirm the seal size, I ordered a set pulled the forks apart and bingo too big....