missing

First the bike started great with Spark's rewound SEM, and I was working on setting the idle and the mixture screw properly, when... HUH? Stalled. I thought, okaaaay, I must have set the idle too low, no biggie. But then I realized the kick start was stuck. I thought the worse and PMed a...

I cant find the Oil-seal behind the bearing in the clutch cover to the water pump shaft, in the 04 sparepartsmanual?? is there anyone out there knowing what part-nr it is? Maybe i have become blind, but I cant see it, strange! Regards

I borrowed a picture from Joe USA's gallery which shows the left side of the carb on his 04. There is a cavity with two screw holes that has an unfinished look to it. I found an exploded FCR diagram that does show a diaphragm, spring and cover that goes there. Apparently it is not used on all...

While repairing an oil leak from the starter o-ring I noticed 2 teeth missing on the larger cog of the Gearwheel Starter/Balancer. The larger cog is about 5cm in Diameter. I have been quoted $350 AUD for the part and a 6 to 8 week wait. Seems very expensive and even the dealer was surprised...

Hi, my berg is an 501 build in 2001. I got a problem with my crankshaft. The damaged crankshaft was 160mm but at the repair-set i have bought the crankshaft is 165mm. And this is definitely to long. I know that my dealer has ordered the crankshaft for the year 2003. He told...

my 96 husa 501 fe has a popping and hesitation at low speeds and also after a longer ride at higher speeds.full throttle is no problem till it heats up then it will not idle at all.a 10-15 minute cool down and it will fire right up then the above happens all over again.the exh is sealed with rtv...