kickstarter

hello everyone, I have a question if it is possible to fit a kickstarter from another husqvarna motorcycle, ktm 520, lc4 or other, I mean the kickstarter itself, not the shaft, the motorcycle is a Husaberg Fc 600 2000

Hey guys this is dirt bike Dave 88 I need a Kickstarter for my 501 it's a 1996 I live in Phoenix Arizona

Hi all, I have a 2004 FE650 (without kick-starter from factory), just wondering if anyone has a full assembly they'd like to sell or know somewhere that might sell at least some of the parts. Thanks

I just tried to start my FS650e '08 and while trying to find TDC I heard a "plingy" sound coming from somewhere inside the engine. Normally I cannot push it through TDC once it's up there and I need to use the valve lift lever, but since the sound I can just push it through TDC. Please help...

Hello. The kickstarter spring broke, so i have to replace it. The problem is i don't know how to tension the spring. I can't find any instructions on how to do it. The kickstarter would'nt return. I really need some help :) 2005 Husaberg 650FE

Hi, I have a husaberg FE 550 E model 2006. The kickstarter broke. Could you tell me where to buy another one? I would like no know too if there is another kickstarter compatible. thanks in advance for any help

Replaced waterpump seal, and had to "reset" that kickstart spring(6 times up to now). I heard it pop out a couple of times. The last time I bolted the case up of course the kicker wouldnt ratchet back. I removed the case and put the kicker back on it....works fine. Starting to think that the...

so i was kickstarting my bike this morning, and right as i gave it a nice big wallop it kicked back hard and now the kick starter is limp and the pawls or ratchet or whatever wont engage! any advice as to my next step? i imagine its going to mean removing the clutch side cover to access the...

Lost my kickstarter from a 2008 FE 550. Anyone have one they want to sell?

Hello everyone! Have bought old 1999 FC400 cross bike with broken kickstarter shaft Where is the best place to buy it? As far as I understood it's 00010706 part number from this catalogue (it's 17 on the picture)...

Hello, Tore into the engine today. Found that the kick starter has started to push into and deform the case along the one edge. This is bad because now the kickstarter assembly doesn't fit properly and is likely causing wear and continual damage to itself (and possible the rest of the engine...

Hi! While rebuilding the Husaberg Fs650 2002 engine, I noticed that I don´t for sure know how this kickstarter shaft should be monted. It need to be synchronized with the decomp on the other side of the shaft. I tried to mount it as I thought it should me mounted but I am not sure (on the...

Hello I just bought Fe 650 and previous owner messed with kickstarter so it was jammed. I removed assembly and there was little damage caused by wrong fitting. I tried to re-install assembly, it seemed fine before bolting clutch. Kickstarter gear moved freely both directions until lever was...

Hi. I have 2003 year Husaberg 650. But engine with 1-phase generator and has not "Cylinder head bleed screw". I think that engine is 2002 or older. And now I have problem with kickstarter. It slips always and engagement key kickstart don't engage. Is kickstarter shaft from 04 and newest Husaberg...

I have fitted a lithium battery in my fs570 wich performs great starts very easy in any condition even in 1st gear. Now I whent for an offroad ride and my bike was VERY dirty so before heading back home I stopped at carwash to get the most mud of the bike I used a plug for the exhaust but I had...

Hi, I own a 2004 Husaberg FE 450 E. Today whilst changing the oil and filter I went to kickstart it and noticed a chunk of metal drop on the floor. I searched around until I noticed the bolt holding the kickstarter on was loose and the stepped washer behind it was broken into pieces. Does...

Anyone experience with replacing the kickstarter axle from a 2003 FC 550? Today i tried to start the FC/FE 550 of a mate and the kickstarter axle broke. Weird experience to encounter. Is it hard to do? Do you have to take the engine out of the frame? It's a strange bike. It has lights and was...

I've started to take my clutch side case off to install the Orangeberg weep hole kit and have been stymied by a very hard to remove kickstarter, I've tried heat etc, etc,! I'm in the process of modding a puller up to fit, hoping that works. Anyone have any tips, this should be very straight...

Greetings folks, I'm having some trouble restarting my bike when hot. Kickstarting finally works when cold (albeit not properly adjusted yet, still takes it's time to get going). When hot the kickstarter just seems to "fall through" most of the time, i.e. I get it to tdc or just past as usual...

I need to reset the spring on my kick starter. Last winter when I had the bike apart I indexed the kick start shaft at least a half turn too much in the counter clockwise direction. I can use the kick starter but it will not return on its own. Today I took it apart hoping to pull the shaft...