idle

I'm new to both Husabergs and fuel injected bikes. Point me in the right direction. I just bought a 2010 FX450. It had a new fuel pump installed last year. It runs fine at high rpm, but when I blip the throttle off idle, the engine sputters and dies. If this were a carb bike, I'd start by...

Hi guys. I got my berg up and running with new liner, piston and valves. Now I have an issue with lean idle, where I have to set the idle screw to almost maximum when warm to run without choke, with choke the rpm rises drastically and I have to back off the idle screw multiple turns to have...

So I have a 2006 KTM 250sxf w/ fcr carb. The bike idles well, starts easy, has great throttle response, no bog. The only problem is when I'm putting around with no real load/no acceleration say 1-2 gear with the throttle rolled just above idle it sounds a bit rough. How should i go about...

I have a 2006 Fe550 that has been stored since last year. When put up last year it was running great and I even took it out on the road a few times over the winter with no problems. Getting ready for riding season I have cleaned carb, replaced plug, changed air filter and checked for intake...

Here is a short vid of a very pronounced knocking noise coming from my 05 fe 650. It is really noticeable on cold startup, low idle, and shutdown. The bike idles around 1500, and if I run it up to 2000 the noise abates. It always occurs on shutdown just before the motor comes to rest. The...

i have a 1999 fc 501 I'm the second owner bike has all ways ran awesome the the other daythe beast died idling before i got to go ride now she won't fire up again i have no idea were to start every shop I've called acts like i have the plague when i tell them what I've got

Hi guys, I picked up a brand new 390 several weeks ago and have been finding that after 10 minutes of riding (once fully warmed up?) the idle is much much faster than it normally is after starting. I have identified the idle speed adjustment knob and confirmed it's not pulled out. Also, i did...

Hey Guys, I thought I would ask, My 2005 fs650e has had this problem since the middle of last summer. When I start the bike (2 kicks max) with the choke on it idles at 3500rpm. when I turn the choke off It will go below 1500rpms and die unless i keep my hand on the gas. once the bike is warn...

I just had a major rebuild done on my bike and after assembly, it starts and runs fine with the idle speed adjustment screw pulled out, but immediately dies when it is pushed in. Before the blow up, the bike started flawlessly every time with no need to pull out the screw. I can get the bike...

09 FE 450, stopped running right a while ago, took the injector apart, cleaned it using the 9v battery method, bikes running alright again but rough on the bottom end, very surge-y if that makes sense, lumpy and almost as if it fires every other time? any ideas, i was meticulous for clenliness...

I have a 2011 Fe570s with a FMF slip on and JD jetting. No matter what the setting on the JD it back fires when the throttle is released also the idle fluctuates. I am at 3500 ft elevation in South Dakota. Before I did the JD Jetting and the slip on It really backfired because of being to...

Hi from Estonia ! I was riding off road and suddenly i noticed that when i pull clutch in or stop, the idle is very low and eventually dies. Started up good and after some revving it sometimes stays on good rpm but after some more revving or riding it still wants to die on idle. No bogging on...

Gurus, I have a new 2009 FS 570 here in Lima Peru. I purchased this from run out stock and it now has 45 hours and 2000km's. Last week while riding home I pulled up at a set of traffic lights and it stalled which was odd. The bike since then has developed a very erratic idle issue that isn't...

Hello chaps, ive got 2009 570fe, the last week or so its been struggling to tick over on idle, stalls after 20 seconds or so. I went to adjust the Idle on the choke, choke pushed in, but it dosnt seams to make any diffrence what so ever wether I turn it clockwise or anti clockwise. Any ideas...

First of all, hello, I'm new here :D My name is Nino and I'm a new owner of fs650e 2004 with full akrapovic :) my idle is too high. Where is screw on FCR41 for fine tuning? Second thing is that when bike is working on idle (too high obviously), coolant went from that pipe out off the bike...

I have a problem on my 2007 FS 650. The idle is a bit low. When turning the idle screw nothing happens!! The idle does not change. Any explanation ?? Thanks Ragnar

Good Evening, I have an issue where my bike is running good (not perfect) but the biggest issue is that it is slow to return to idle...(the bike is 100% std) The bike had been laid up for nearly 8 months while I had a knee reconstruction but I'm now ready to go so I got it out, some fresh fuel...

I have a 98 fc501 I supermoto'd. I was reading the manual and it said that the engine can't idle for more than a minute or catastrophic engine failure could occur. So far I've just been revving it every 5 secs or so when I'm at a stoplight. Anybody know anything about this?

Has anyone had this issue..... When i blip the throttle the revs return to around 2300rpm then slowly drops to an idle maybe 3sec . Had the the throttle grip to bits and adjusted the cables and all that seems to be fine. When i snap the throttle with the engine off the butterfly is closing as it...

Can anybody help with a small problem, I have a 2010 FE390, and it has started to race at idle then after a few second the idle speed drops to what i would expect, blipping the throttle doesnt really seem to make a difference and when riding it is starting to pull you into corners faster than i...