counter

Anyone know why the counter balancer driving shaft is a two seal bearing? It seems that the seals would prevent oil from getting to the bearing. Has anyone removed one or both of the seals?

in the doc..it says it is possible to remove the counter balance to eliminate possible failure ..have any of you done this ? if so is the vibration really bad ..if it is can this cause any other problems ? also can the counter balance bearing inner ring be removed and used with the spacer...

Can anyone make comment on how much "better" the one peice 2007 counter balancer is over the 2006 and prior set up? Has anyone noticed any significant other things about the 07 over 06?

Hi guys i have removed the counter balancer bearings (they are both the same) however i can find no numbers on them so that i can replace them from the bearing specialist. I can now only buy the 07 as a complete unit (Counter Balancer) priced at $500 AU and really would like to just replace the...

Hi Guys, To make a long story short, after a rebuild, my 2000 fe501e had a vibration that wasn't there before. I've checked every possible cause, and have now worked my way down to having the cases split on my bench. I suspect it may be that the counter balancer is not aligned properly...

Morning Guys, A bit of advice required down in deepest darkest Kent. I did an oil change on the 'Berg a couple of weeks ago and the oil came out looking like red metaflake paint! Had a run over it with a magnet and the residue seemed to be 99% aluminium so I mentally diagnosed a knackered...

How much play should there be in the counter balancer in a 1999 FE 600E?? :angry: I thought the answer should be none!! Has anyone found one yet??? Are there updated bearings for this old machine?? it has roller bearings (needle bearings) in one side and ball on the other did the failure...

Per slowjoe I am going to reassemble with out counter balancer and see how it runs. Any suggestions or warnings welcome. I will be talking to you soon for parts Cody

HELP: I NEED A COUNTER BALANCER AND CORRESPONDING GEAR. ANY HELP WOULD BE GREATLY APPRECIATED AS HUSABERG CORP. LEFT ME HIGH AND DRY TO FEND FOR MY SELF. I AM NOT HAPPY ABOUT IT. WHAT CAN I DO? LESS THEN TWELVE HOURS ON THE BIKE AND IT DESTRUCTED THOSE PIECES . GEARS IN QUESTION ARE...

Hi, In the Iridium topic I started a handling question. However, in the line from work I remembered that I read in the flyer that the counter balancer should reduce the inertia of moment. Hence, the bike should be easier to handle in the curves. Not gain stability. This is a review of the...

Hi everyone My trusty little 470 Berg (engine) is at my local dealers (Gary Grover Racing) for a bottom end rebuild as the mains had started to go. I race supermoto and really like the way the power is delivered as it revs and just keeps on revving. While the engine is apart I thought...

Counter balance shaft gear keeps coming loose ? I've replaced the woodruff key as the old one broke up. There seems to be no wear on the shaft or gear and I trimed the new key down when fitting it but the noise has come back again ? Any advice Guy's. :oops:

OK, ive decided to keep my counterbalancer, but ive got a new bearing for it. how do you get this thing off, do i use a puller or what?