conrod

Good evening, I am looking dimensions for Husaberg 644 rod Between Centres: 135mm? Big End Diam. : ? (40 i think) Small End Diam : 20mm? Bid End Depth : 20mm? Small End Depth: 20mm? Thanks!

Pictures added to my gallery of our news cranks and rods. Crank is 80mm stroke, direct replacment for OEM bell crank. Crank is billet machined from ASi 4340 and cyanide harden and ground. Threads on drive side increased from M16 x 1 to M24 x 1.25 to stop them stripping, which they do on OEM...

Hello there, Some parts turned up today for my 02 fs650,and a new conrod was one of them.Problem being that the rod length is 1mm longer 135mm between centers compared to the old one of 134mm. Going by some of the other forums this is of an 03 model.Can this be used with out any problems?? Do...

hi does any one know where i could get a 1994 501 conrod? big end pin 30mm rod width 18mm (between webs) rod length center to center 125mm wrist pin 20mm i have a ktm 525 rod but this will take some considerable machining to fit the webs and i would have to use a 4mm spacer...

Maybe next week they tell me... I could have had one shipped and here from the US by now surely..

Does anyone here have experience with the use of aluminium/carbon composite conrod in 650-engines or similar applications? Best regards, /Dr_C

And there you have it the culprit...

Is changin the conrod a job a garden ched wrencher can do, or does it need to be aligned and such wich would make it a pro's job? What about putting the cases back together, is it as simple as just bolting them back together or do they also need to be aligned in a special manner? Thanks...

Just need to know, the rod lengths for the 650 from 2002 to 2004 if anyone has this info? Lloyd

Hi I am new to this forum and to Husaberg motors, I am an engine builder in the UK and I have just taken on a Husaberg project. I specialise in big bore engines and will be taking the 2003 FE 650 motor that I have out to 750cc. I propose to do this with 105mm piston, 86mm stoke billet crank...

Hi, Which models lubricate the conrod bearing through an oil duct in the crankshaft?