clamp

just after some advise on how far to lower the clamps on the fork tubes I'm 172cm high 87kg with out gear ride 05 450 fe with heavier springs front and rear i did lower them 22mm (12mm bar raisers) found the front a bit stiff but very stable but the back end was very skatey, i could also touch...

Ok, just spoke with BRP again and they are ready for production of the Berg Top Triple clamp. These would be: Rubber Mounted Black 22 mm offset. The Scotts Damper options include: Option #1: Upper Triple Clamp as described above, lower bar perch (black) and a 1 piece upper bar perch...

Just wanted some feedback... I am in the process of working out a deal with a very reputable aftermarket triple clamp company and was wondering if there is any interest in aftermarket triple clamps. Details are still being worked out, however, these will hopefully include: Rubber Mounting...

I pick up my new 06 Fe450e tomorrow. My bar riser and handguard choice needs to work together. I want the fastway handguard system which mounts to it's own bar center top mount. This system works right on top a KTM standard bar mount system. I have seen it many times on KTMs. If the KTM...

:x I've got the triple clamps off of my '02 FE501e. Reason is the bottom bearing is SHOT. The problem I've run into now is the steering stem is stuck in the bottom clamp. So far I've heated & beated the thing but I can't get it to budge. Any suggestions?! Thanks, Rob

I have a 2004 fe450 and I wanted to know if the ktm triple clamp with the 20mm offset will interchange with my berg set(22mm)?? Any special dohickies needed to make it work?

Been looking through the site and can't find torque spec for triple clamp to fork tube. I'm sure it can't be much, but would appreciate Husaberg recomendation if anyone has a source. Can't find it in repair manual or fork repair manual. Please express it 'Foot-pounds". Bike is 97' FE600E...

besides makka doing it, has anyone else been fitting KTM TCs and their 18mm offset? experience? regards Taffy