cdi

hi all, i'm new to the site and new to bergs, just aquired one and it ran like a bag of spanners at just above tickover, spitting back and blowing the carb off, ive checked the usual things , valve clearance , carb , plug gap, also even though it was like this it used to start realy well, but...

anybody use a msd/cdi (single cyl) #4217 on a berg? it has two programable advance curves--

I have an ongoing electrical problem. The stator was giving a voltage output but ohms were showing a short (red to black over 20k ohms - spec is 3k ohms) I have managed to get a reconditioned one that was surplus to another berg owner. I fitted it and the Specs seem fine and voltage appears...

I have bought a keihin FCR41mm with TPS from ebay. I bought it for my FE400 which was previously equiped with a Dell orto phm38 This dell orto does not have TPS, so my CDI does not have a TPS 'connector' I think? Should I buy a 'Husaberg certified TPS CDI unit' or can I modify my current...

Hi, I have a KTM ignition that has only on-off and has two normally open contacts when OFF - both are closed when ON I am not that good at electrical but I have determined that I am going to cut into the primary red/yellow wire off the fuse block to interupt the starter relay circuit and...

Greetings fellow Husaberg owners, I am in dire need of a new CDI unit for my 1999 FE 501. I would be happy with a good second hand one if available. Have pity on me. I have had this bike for nearly 12 months now and I haven't been able to sort the ignition problems until now. Imagine having to...

Hello all, Is there a difference between the cdi box between 2004 and 2005 or later. Is it possible to have a different powerline,or are they all the same. Madero

My CDI ignition module died recently in my 600fe and the best I can find that I can afford for now is CDI out of a 650. Will the mapping in this module be near enough for my 600.

hi folks, does anybody knows the price for a new cdi unit for an earlier husaberg 600? not the stator, i am talking for the red box which includes a printed circuit board, a capacitor and the ignition coil. thanks in advance

The SEM CDI on my '03 FE501e has failed. Anyone have a spare good CDI for sale or know of someone parting a bike? Thanks

This site has some very useful information on the SEM stator as well as how to build your own CDI: http://www.transmic.net/gbindex.htm Check the link section!