cable

Hi I'm not sure if my throttle cable is standard or whether it has been modified but it seems like it is too short! The throttle cable has always been routed down in front of my bars, I have just put new higher rise bars on and at the same time I wanted to route the cable/s behind the bars as...

Where might one find a clutch cable for a 99 501 FE? Preferably in the USA.

After a disagreement witha CRF earlier this year my trip computer cable is cactus. I was positive that there was a post about a tougher aftermarket cable but cant for the life of me find it, and my google searchings have proved fruitless. Does anyone have any suggestions please ?

Hi, would any one be able to tell me the part number for the de comp cable that runs from the head to the kick starter. I have found this on e bay and it appears to be the right one for my 2002 650?? Regards upshegoes. http://cgi.ebay.co.uk/Genuine-Husaberg- ... 2a07ec0d1d

G'day all, Need a speedo cable to get my bike road registered. Are these a one off hard to find part? Hoping they are interchangeable with newer ktm part or something easier to aquire.

hello I need someone in the UK who is out riding every weekend to test out a choke cable for me if they can? all you need is a pre-2004, a dell orto carb that's been refreshed, in good nik and the leccy boot. I have a choke cable i need setting just right on a bike so it fires first time...

Greetings chaps, Just recently bought myself a '02 fs 650. The/a previous owner had removed the decompression handle and cable and I'm now putting it back on. On page 22/figure 9D of the '02 users manual it shows a 2mm +- 1mm minimum clearance for the decompression cable, am I correct in...

I need a cable for my bike can anyone point me in the right direction I'm from VA thanks

I need to replace my throttle cable, including the 'tube bend' on my '03 FE400. Is the cable and / or the tube a common part with any KTM model? If so where do I get the part number cross reference? Getting parts for my Berg is a nightmare in the Toronto area!

hello not very often we develop something new on the older girls now is it! i have been converting the manual decomp to operate the choke knob on a few bikes recently and beside the fact that it's a little shorter than desired it has been fine! one thing to note though was that when...

this speedo is doing my head in and yes i no i should get a digital one but i want to keep the beast as original as pos, ive fit the cable numerous times but icant get it to work the trip works fine but no speedo i took the head off and the cable turns when i spin the wheel, its the second head...

husaberg fs650e 2003 does anyone know wich one of the three yellow cables on the rectifier that should be connected to the blue cable from the stator? my bike kills battery after battery... and when it has destroyed the new battery it only runs on idiling, if i use the trottle the engine...

CRF FCR 41 carb on a 2002 Husa. Tried fitting the OEM Husa (2004 + cables) to my carb, but there too short. I can only fit one of the two. If I fit both I can only open the throttle halfway due to the fact that there is too much tension. Is the cable 'housing' on the Honda FCR's different...

I have a new cable to change the stock choke cable to a longer one for easier access but the plastic knob on the end of the old cable seems to be molded on there. Anyone know how I can get this off and fitted to a new cable (the new cable has the same nipples as the old one)? Any better...

I am currently rebuilding my top. Rocker cover exploded and bought a newer one, had to reuse my rockers. I have bolted the rocker cover and currently letting the sealant cure. The decomp cable seems to be loose and does not seem to ever need to be pulled to let the piston pass TDC @...

I have a quick question. I went to adjust the clutch on my 98 FE400e and found that down where the cable ends at the engine case there is a spot where the threaded portion of the cable housing goes through a small hole. The cable then attaches to the clutch lever. On my bike there are two...

Does anyone know were I could find cheaper (other than the OEM) replacement sensor for the odometer? This sensor mounts on the brake caliper and connects to the odometer. I just need the sensor and NOT the complete cable with connector. I would like to install one sensor per brake...

Hey I was wondering if there was anyone else out there who has put a hot start cable on their 41mm keihin. I recently installed one on mine and it came with a very small "o"ring that i wasn't quite sure where the o ring went if anyone out there has any idea it would be nice to know. thanks

Hi guys, some how I ripped the wires out of my sensor on the bottom of my forks, is it possible to get new cables? I called the dealer but their system is down atm. The other option was to go one of these http://cgi.ebay.com.au/TRAIL-TECH-ENDUR ... dZViewItem Has any one tried one? any...

I have an '05 FE650e and noticed in my manual that the clutch line and decompression cable were run behind the triple clamps on the bike in the photos. My bike came with them in front and they seem to bind slightly with the wiring harness. Which way is correct, my Yamahas seem to have them in...