390

Sharing my fuel pump parts woes in hopes someone else may have an easier time than I did. My initial failure was due to a bad Fuel Pressure regulator. (pressure test was only 5psi & immediately dumped the pressure so the diaphragm was blown dumping the fuel back to the tank) Since my bike is an...

Hi, The posts on this community have helped me a lot already! I will try to keep this short. Last year my engine seized (Husaberg FE 390, 2010) while riding. I have changed the cylinder, piston, rocker arms, cam chain, etc… After these changes the engine worked again. But after letting it...

Guys sorry if this question has been asked before But how do you adjust sag on a fe 390 Can’t get a tool in to adjust the spring. Do I need to take the rear suspension out to adjust the sag? Or is there another way? Cheers Dan

Fe 390 2011. 7500 odometer...ohlins front forks cartridge.good all around bike.cosmetics /plastics.some faded..laced up rear fender..usual scratches etc New tyres.chain sprocket.nitrogen recharge..road registered..£2600 Contact [email protected]

my fe is nearly ready for road but fir insurance and security reasons I need a keyed ignition. Slavens racing seem to be on back order.does anyone know of a plug and play kit maybe from a ktm that will work or have used a universal kit and want to share how you done it? Thanks Derek Ireland

I found an FE 390 for sale -- cheap (yeah I know) -- it starts fine, but dies after 30 seconds. Restarts, dies. Also it is gutless until mid throttle then goes like normal. Thoughts?

Bonjour à tous ....Faire une offre !

Hi guys I’m in Australia and I’m really struggling to get my hands On a repair service manual for my fe 390 2012. I’ve tried many places with zero result. Can anyone please help out a fellow Husaberg owner. Thanks guys

Hi there - new member here. Getting ready to jump back into the cycle world after a 20 year hiatus. Was a street rider before, enjoying 400-600cc street machines in my youngen days. Now I'd like to get back into it, looking at riding mild trails, fire roads, two tracks here in CO. I don't...

I recently bought a 2011 fe 390 with a nice graphics kit on it,I'm looking to get the same again to freshen it up. It has brands like michelin fmf twin air and airoh on it. Has anyone seen this set before or can point me in the right direction

Good day guys: Husaberg 390 loosing mineral oil into engine after it sits for a week or more, I'm sure it will get worse in time. Does anyone have a part number for the seal on the oem slave cylinder ? or a recommended fix besides replacing the complete slave cylinder? thanks

Hi all, I've got a 2010 FE390 that has been amazing until two months ago when it died on me while out on a ride. Engine would turn over but would just not fire. Replaced the fuel pump and that seemed to do the job. Got back out on the trail, started the bike and it would idle for about 10...

Lads and Ladets Home and hosed Just about to pick up a 2010 FE390 40hr with 1880km looking to do the flowing single trails, and at half the weight of my Dr650 adventure hoping it will suit, any input as to what i should go over before going for a ride?? I'm buying it from a dealership...

Hello, I’ve been creeping on this forum since last week, when i found a low km/low hour 2011 fe390. The previous two owners set it up as a street legal dual sport, and used it for trail riding. It only has 80hrs, 3200km on it! Looking forward to many miles of fun!

hello all. Have had the bike since new but dot put a lot of hours on it each year. Actually didn't even ride it last year:( Its a 2011 FE390 with the map switch, full akrapovic ti exhaust and radiator fan.. otherwise stock.. besides cleaning the gas tank slime off the filters when new...

Hi good folks, just purchased a 2010 390 and joined the forum. Thanks in advance for your help and wisdom. I discovered a concern when coasting down my hill today. To reproduce the issue and for troubleshooting purposes, I coasted with the engine off, clutch in, and in gear, I'm getting a...

Hello I'm from Portugal, and I have a 2010 husaberg fe 390

Hallo everybody, I would know if is possibile to chance Houston and cilynder from 390 to 570 in my 2012 bike and what the parts I need to chenge in electronics or mechanical. Thank you everybody, I' m from Italy and my English is not perfect. Arrivederci e grazie.

Where can you buy back fender, side panels and radiator shields. New to forum. Help out a rookie

hello everybody i got my fe 390 1 year ago and all was well. about 3 months ago there were times when the bike wouldnt start when cold. it does this once in a while i cant figure out what it is. changed the battery and spark plug but i reckon its either electrical or fuel. i would appreciare...