300

Hello guys!I have a problem with the electric start. When the engine is cold it does not turn the engine at all and when the engine is warm it turns the engine but not hard enough to start. 1.New bushings 2.New starter motor 410W 3.New Bendix 4.I greased everything What can it be?

Needs to be electric start, love my 390 fe but want to have a second berg in the garage. Prefer less than 100 hours and somewhere in the midwest if possible

Hi just wondering if anyone could help me I’ve got a husaberg te 300 2013. With wp closed cartridge forks. I done a hare and hounds and blow a seal. I’m happy to replace the seal and I know the capacity is 607ml but would anyone be able to tell me how much in the bottom and top of the cartridge...

Husaberg TE 125, TE 250, TE 300, year 2013, owners manual:

Hey there, Can't find a TE300 wiring diagram/service manual to solve this. I wired in my headlight (35W 12V halogen lamp, Polisport headlight) Powered it off the yellow wire, not the yellow-red wire. It runs just fine of the yellow-red but I'm told that is incorrect and it drains the...

FAO Admin: please delete

Hello, I'm having some clutch issues and need some of your knowledge and wisdom to stop me from going insane and emptying my bank account! I've got a 2014 husaberg te300 it's always had a slight bit of clutch drag but nothing too bad. Recently though its got worse... The bike won't start or idle...

Hi guys Im from Spain and i am having some trouble finding a set of plastics for my bike. Can anyone tell me what year KTM or Husqvana plastics will fit?

Hi I just bought a 2014 TE 300. I noticed that it doesn’t have a map switch- was this a standard feature or not? Also I read somewhere that the vforce reeds were standard but my bike doesn’t have the vforce label on the reeds block. Please could someone confirm whether the above were...

Does anyone know a company/friend who still have a set of black plastics for the 2010 tm 2012 husaberg 300 on stock and for sale? partnr 8120805400030 I have contacted cyclebuy and a lot of other webstores i found with google, but no luck. Anyone tips?

Good Day Please assist. I have a Husaberg 300 TE 2013 not Charging, Tested the voltage on both + and - terminals and its not producing any voltage higher then 12.8v. Battery has been tested and working fine. When bike idles or revved no increase in voltage. So I suspect Voltage Regulator gone...

I have found an TE300 -13 that hasn’t been rode since 2013. The owner bought it in 2013 and rode 22 hours and it has been in his garage since then. I will buy it since it’s a good price and it looks almost as new. It’s all original and now I’m wondering what mods you would recommend me to...

Hi Guys, New to the forum and I have a recently purchased a 2012 TE 300. Its just worn out its first back tyre. I was given a new michelin x light rear tyre when i bought the bike and was just wondering if this is a good change to make? I should add this is my first ever bike :eeeek...

I am looking for a low mile/hour 2014 TE 300. I'm in Michigan but would be willing to travel a few hours to get one. Thanks.

What's the rebuild interval for a 2012 TE 300?

In US dollars what do these go for on average? I'm about to pull the trigger on one. I've owned KTMs my entire life and know my way around a KTM well. I know that the Husaberg come from KTM but does the 300 XC-W and TE 300 share a lot of the same parts? I have a hard time finding after market...

Hi all sorted electric start so thought I would start on engine bike doesn't idle well and when ran for a couple of minutes the manifold glows red is this the norm??

I am looking for a right side radiator for my 2013 TE 300...or the equivalent from other years.

~Hi all got the lever and cable is there anything else needed to fit this any info would be great.

Hi all just purchased a 2012 te300 getting it road legal here in the uk but have a few problems first up is the electric start doesn't work thought it might be battery so hooked up jump leads and nothing just a clicking on the relay thing next to the battery checked fuses both ok,next up is the...