- Joined
- Jun 13, 2007
- Messages
- 3,871
- Location
- south east WA Australia
:dontknow:
Conrod/cylinder sleeve
- Thread starter ruisantos
- Start date
Help Support Husaberg:
:dontknow:
- Joined
- Apr 2, 2014
- Messages
- 64
- Location
- Canada
I think Taffy meant its 125 overall... and not 125 center of hole to center of hole.
- Joined
- Jun 13, 2007
- Messages
- 3,871
- Location
- south east WA Australia
maybe ... he has written C to C, but its hard to tell with all the acronyms:cold:
if 125mm is required; the 560 rod has a 20mm small end bore so if needed you could rebore it to 22 and change the centre to 125
if the pin requires modification to fit this provides another opportunity to adjust the required rod length but the pin information isn't being shared.
piston dimensions and squish are also needed to get everything right
measuring everything up an getting a custom carillo is the best option and the sooner they are ordered the sooner they arrive, check out these babies
http://husaberg.org/marketplace/11326-billet-cylinder-head-38.html
if 125mm is required; the 560 rod has a 20mm small end bore so if needed you could rebore it to 22 and change the centre to 125
if the pin requires modification to fit this provides another opportunity to adjust the required rod length but the pin information isn't being shared.
piston dimensions and squish are also needed to get everything right
measuring everything up an getting a custom carillo is the best option and the sooner they are ordered the sooner they arrive, check out these babies
http://husaberg.org/marketplace/11326-billet-cylinder-head-38.html
- Joined
- Jun 13, 2007
- Messages
- 3,871
- Location
- south east WA Australia
FWIW
Travis has 3 KTM 560 rods in stock
Travis has 3 KTM 560 rods in stock
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
