650fe clutch sprag spring

Mojoberg · Oct 28, 2022

my starter slips always when it’s cold and half the time warm. I thought I was told that there is a way to fix the sprag spring by tightening it up or something of that nature. Is this true

ned37 · Oct 29, 2022

first thing would be to remove the kicker, and the water pump crap, then the cover. hold a finger on the shaft of the small gear at the top (torque limiter), to keep it from falling out, hit the start button and see which device is the culprit. could be either.
if it's the sprague, a fork seal spring aroud 40 mm will tighten it. if torque limiter, it takes a little machining.

Mojoberg · Oct 29, 2022

ned37 said:
first thing would be to remove the kicker, and the water pump crap, then the cover. hold a finger on the shaft of the small gear at the top (torque limiter), to keep it from falling out, hit the start button and see which device is the culprit. could be either.
if it's the sprague, a fork seal spring aroud 40 mm will tighten it. if torque limiter, it takes a little machining.

I will try that. I think I met you in crested butte at the rally. I will let you know.

650fe clutch sprag spring

Help Support Husaberg:

Mojoberg

Attachments

ned37

Moderator

Mojoberg

Similar threads

Register CTA

Recent Discussions

Recent Discussions