Joined Aug 2014
64 Posts | 13+
cambridge ontario canada
42 pj ordered. Will be in Tuesday. Took the bike for a good rip today. I'm noticing a hanging idle. I have to let the clutch out in 1st when I come to a stop. To bring it down to regular idle. Then it's totally fine.
Is this a needle clip setting? Or is air leaking past my pj screw?
Is this a needle clip setting? Or is air leaking past my pj screw?
You're too far out on your screw. Gently run the screw in until the idle starts to stumble, note that position, then back the screw out until the idle starts to speed up. Note that position.
You're sweet spot will be somewhere in the middle of the two positions.
When you blip the throttle you don't want it to bog out (too far in), and you don't want a hanging idle (too far out).
Hope this helps.
You're sweet spot will be somewhere in the middle of the two positions.
When you blip the throttle you don't want it to bog out (too far in), and you don't want a hanging idle (too far out).
Hope this helps.
Joined Aug 2014
64 Posts | 13+
cambridge ontario canada
Well. Took the bike for a rip. I'd say it starts up super easy on choke. Let it run for 3-4 minutes so it would idle without choke. Idle seems quite low. Snappy throttle response. Notice a great low end power improvement. However. The hanging idle now seems worse. It will idle quite high then taper down and nearly die out. Any suggestions
Joined Feb 2003
3K Posts | 384+
Escondido, Ca. USA
Similar threads
Register CTA
Register on Husaberg Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
