wrench

On a 2014 FE350, I just changed my oil for the first time. There is an icon on the speedo of a wrench that is supposed to appear when the selected oil change interval has been reached. In my manual, it explains how to turn the icon off, but it reads as though that stops the wrench icon from...

Went to remove my plug from my Fe550 (2005) for the first time and a standard spark plug socket will not fit down the hole. Will a think wall socket work or do a I need special wrench? Thanks

The bike is new to me and I am trying to get equipped. Motion Pro Rider Wrench has been recommended. Which size should I get? I was told the rear is 27mm, but I don't know the front. Anyone with a quick answer? Thanks.

Ive come to check my valve clearance etc for the 1st time today. However ive got to the first step of taking my spark plug out and have ground to an instant halt! The socket ive bought to do the job is slightly to wide to fit between the gap in the engine where the spark plug is. As a...

Im looking for a spoke torque wrench. The Excel only goes up to 6.9 mil. Is that enough? The 7mm wrench fits. Is 6.9 the right one? . The Fasstco tool says 6.8 and then 7.4. Where's our Husaberg spoke torque wrench? Pollo

i appear to have overengineered my old plug wrench i made after giving away my original. i told speaker that i would make him one and after measuring it to cut and weld, i noticed it would be easier just to cut it and drill a couple of holes. it makes it easier to get in and out and also to...

I'm deciding to purchase a spoke torque wrench (Fasstco Brand) and just want some feedback from the members on what they use to keep their wheels in tip-top shape. Husaberg (FE400 2001) spoke nipples are approximately 7.0mm. The Fasstco has a 7.1mm splined head which is the closest to our...

is there a special torque wrench for doing tappet nuts, so that you can keep the screwdriver in, while fastening the tappet nuts, when setting valve clearance? ot is there another trick to it?

where can I get a steering nut wrench??? motion pro was no help. part #?? LT

I was just reading over the FAQ. Glancing through the valve adjustment section, I noticed: 20•Now, you will need a 10mm box wrench or better yet, a wrench like Grok made, which is shown here. I checked Grok's gallery, and nothing. Anybody got ideas? I have noticed that a normal...

myself not being one of them.... is there anothjer way to secure the flywheel to allow the removal of the nut, besides the "flywheel holder tool" refered to in the shop manual... thanks again for all the help Jared