washer

Hi everyone, Can anyone confirm what the job of this washer is please? Is it just for grounding? I originally thought it had something to do with the regulator but feels as though I am very wrong after seeing it connected directly to the frame on this image! Thanks I'm advance

It has been happening like a thick fog now for some time, you just plough on and get the job done but I recently fitted a sprucwe up kit to a dell orto 409mm carb and to get thew float arms right I had to bend them up. I have noticed this before and not thought too much of it but a job this...

Gday all, I have been looking for an aftermarket kit like the "Bolt" brand of replacement fastener kits. So far all of the kits have the torx head bolts. Not a major issue, but my 04 have any torx head bolts so I was trying to keep it original. Besides ordering OEM and paying a squillion...

Hi, I own a 2004 Husaberg FE 450 E. Today whilst changing the oil and filter I went to kickstart it and noticed a chunk of metal drop on the floor. I searched around until I noticed the bolt holding the kickstarter on was loose and the stepped washer behind it was broken into pieces. Does...

I recently bought a 2010 570FS & have just done an oil change. There was a small badly worn washer in the dirty oil (9mm diam, 7.5 internal diam, 0.2 thick). There were also some metal filings on the drain plug magnet. Does anyone know where this washer would have come from &/or what the filings...

i want to fit a tab washer to the crank to stop them coming undone so i make an appeal for those of you in workshops to look for one that will suit the job. a central hole of 16mm is required. just need a source of them or a bike that they come off. regards Taffy

Whilst replacing my worn clutch plates a while back, I think I may have lost the adjustment washer (which sits between the pushrod and pressure sleeve). D'OH! My clutch still works, but I've had to use almost all the adjustment on both the handlebar and engine levers. What diameter and...

Hey Folks, Not sure if you have ever experienced a cracked kickstart retaining washer? Thanks to my ham fisted ways....i have. After much searching I found a good quality hardened washer that will replace the stock one. It is Caterpillar part # 9X-6165. It appears to be an "in stock" item...

Dellorto gurus ! When trying to set my mixture and idle screws, the smoothest running is with the mixture screw all the way in. I notice the little washer and rubber is missing and wondered if that could be the reason. Please advise Regards Ady

Hi, I recently bought a '99 600FE. I had a problem with the clutch as it wouldn't disengage. After inspection I found there was no adjustment washer fitted. Probably the previous owner forgot to fit one or lost it or something. Can anyone tell me what material the washer is made of...