voltage

Hi chaps, have a problem with charging system on my old 2000 Fe 600. Charges fine 13+ volts until put under load ie headlight on then drops to approx 12.4v DC no matter the rev range...........I suspect regulator rectifier fault? It's five pin type ie 3 yellow 1red & 1 brown wire. Anyone...

Hi all, I have a issue with my charging system where I'm getting a low voltage on the DC circuit at higher rpm. I've replaced the original head, tail and indicators with led types. Indicators and head light were on the DC circuit and tail on the AC circuit. I'm pretty sure the issue was there...

I have a 1994 FE600 without battery, electric starter etc. There is one yellow wire from the stator which connects to the yellow wire on the regulator. The regulator is a small cube with just a yellow and a black (frame ground) wire. I get about 17 volts AC out of this without load. 1...

Hey i messed up wiring from my voltage regulators attatchment plug. so now i have 3 yellow wires missing their places. theres 2 yellow and 1 blue in that plug that comes from stator. (original sem) bike is fe 501 2000 Any help? pictures?

Hi All, First post here, I've just swapped my k100 cafe racer project for a 2002 fe400e. It seems in pretty good condition. First thing is have noticed is none of the lights work. I pulled the tank off and was met with a massive tangled mess of wires. I found a wiring diagram online and have...

Hiya, Just went for a short spin on my 570 with a fresh, topped-up battery in. I ... it ran quite a bit stronger than I remembered?! As in instead of it being relatively easy to have the front wheel slip to the sky, it felt HUNGRY and the wheel WANTED up and there were JOLTS to the chassis...

I'm currently rebuilding my berg, swapped in a overhauled engine and I noticed that I had three yellow wires coming from the voltage regulator that were not connected to anything. Been like this since before I got the bike. Dug around wiring diagrams and found they should be connected to the...

Hey guys Bought a Fs650e a while back and have been in love ever since. Recently injured my knee so while im off riding i have stripped bike to a frame to fix everything and make it brand new. Just before i stripped it down i noticed headlight was dim, so i got out multimeter and checked...

Row of powder machine is equipped with thermal power plant, the motor power of 220 kw, voltage is 6 Kv. Motor shaft extension end use 2322 e cylindrical roller bearing, the shaft extension 6322 deep groove ball bearings. In 2004, the operation of the motor shaft extension end bearing...

Hi I Recently bought a '95 FC600 which after a bit of tinkering I have managed to get running.. The bike has been fitted by a previous owner with a basic electrical system, headlight, stop/tail light and horn with a battery under the seat, so it can be MOT'd, I live in the UK. What I need to...

Hey guys im brand new too bergs only got my 05 650 a week ago and i love it! but.. the brake/tail lights and headlamp have been giving me dramas, they seem to be really dim. so i got the multimetre onto it and im only getting about 3.5v at the brake lights but 12v off the battery? the earth...

I have a 2008 husaberg 550fe. i've gone through two voltage regulators in the last 6 months. i can still start the bike using a wrench--by touching the positive and negative screws/wires at the same time. i can also kick start it and it will start flawlessly. i live directly in front of the...

After selling my 96 FE600e a few years ago, I have always wanted a Husaberg since. I recently picked up at 2005 FS450c (supermoto) that actually has a title and plates, but never got wired for lights. It has a starter and a battery, but does not charge the battery when running. I purchased...

Heya, Any ideas what might be wrong whit my charging. i upgraded to Xenon kit, the original lighting was AC so i rewired the lightning switch for DC. But as you can guess, the DC lacked amps and the xenon only worked like 15mins at time. After that, and some googling i figured out that the...

Does anyone know what the voltage should be at the fuel injector on an '09, 570? Original problem was a sudden loss of spark, determined to be a bad ECM. Replaced the ECM and now we have spark but no fuel. (engine starts when sprayed with starting fluid, then dies away) Installed a brand new...

ANY ONE KNOW HOW TO TEST A VOLTAGE REG ON A 2009 FE450 ? I CANT START MY BIKE ,IT HAS NO SPARK ,IT SPUTTERD GOING IN TO A GAS STATION ,AFTER I FILLED UP IT WOULD NOT START, IT NEVER RAN OUT OF FUEL,AND AFTER LOOKING AT THE HARNESS I FOUND DIRTY CONNECTORS AND A OXIDIZED BLACK WIRE COMMING FROM...

I got a super light Li-ion battery and put it in my 05 FS650. It worked great for 1 ride and died. Has anyone used one in a 'berg? I suspect the charging system may have exceeded the 14.4 volt max for this type of battery. Does this model have a voltage regulator, cause I don't see one in...

What is the max system voltage people are seeing in their system/at their battery with the bike running? There are some interesting LED lights I have found, but their max voltage is 14 volts - any more than that and they blow. I know some bikes have charging voltages that go above 14 volts (I...

Hi, After a few problems with my charging system and over charging batteries, I`ve got the charge rate down from 16.5v - 17v to 14.5v - 14.8v does that sound ok??? The bikes a 2002 FE400. Cheers Bob.

Hi, I`ve managed to boil a few batteries on my FE400 (02). Finally got round to take a reading across the battery and got 16-17 volts. The bike as a Elextrex stator and all the other electrics work ok. So i got hold of a new regulator from Taffy in super quick time and fitted but i still have...