tooth

Hello all, I bought a sprocket for my bike, but I didn't read the fineprint... it doesn't fit. Mine for sale is a 14 tooth (stock pic of 13 tooth below) I have an '05 Husaberg, but the sprocket fits '09 and up. Brand new, I took it out of the package, realized it didn't fit, sprayed it...

Hello dear, just opened clutch cover, put engine in TDC, and see that my timing is one tooth off, at least I think so :D I was checking by drawing from Owner doc's, can you please check am I write and do I need to adjust the timing, should I remove cam one tooth back? thanks in advance

The engine started to make new sounds today so I took of the clutch cover to check if the crank nut was loose again. The nut was ok this time but there is one tooth missing on the clutch basket. Is this a normal problem? And WHY does this happen? Will one missing tooth make a loud noise? Or is...

Lately my bike started to be knocking noisy under load so i decided to look in the head and under left engine cover. And i found that i have broken to half two teeth on the upper timing gear and traces on crank drivegear :cry: , all other gears (basket ect.) look fine. In oil was only some...

will a 16 tooth front sprocket fit on a 2008 550? the reason i ask is because i'm doing a lot of highway driving and i just changed my rear sprocket from a 40 tooth to an original force parts Husaberg 48 tooth rear sprocket and i lost 15km top end where, before, i cruised back and forth to work...

Oh wise people from berg land... Is it possible to run a 16 tooth front sprocket on 05 Fe550?

I have a fe 400e model 2001 and i found 1 missing tooth on the clutch basket.Last year I had a missing tooth on the gear wheel driving shaft and the part number on it was 230 146 01 coresponding for 2002 model,no 230 131 01 that is for 2001 model. For clutch basket there are 2 models to...

I find I'm lugging the engine in second gear more than I'd like on tight trails. The stock gearing is 15/48. One tooth lower in the front (14) would be fine, but I prefer to go larger on the rear. Keeping the 15 on the front will make for a longer life for the chain and sliders. I think 15/52...

Gentlemen A tooth has sheared off my clutch hub outer. Must i replace it (expensive), or should i be ok as there are about 150 teeth on there ? Anyone managed without problems with a tooth missing ? Will it weld back on ? Regards Ady

Dear gentlebergs: On my 03 FE400e, I had a problem with very rough slow idle and occasional starting problems. My mechanic had been doing a variety of things to try and install an auto clutch per my other posts and thought he would check the timing and rework the jets. When he worked on...