stem

Hi! Been searching to find the correct STEERING STEM BEARING & SEAL KIT for my Husaberg FS 650 2008. i have searched and found ALL BALLS STEERING STEM BEARING & SEAL KIT - part number 22-1032 , but previously I have swapped with a Husqvarna 701 SM, which had part number 22-1026 . I can...

Hello husabergers, I have recently gotten my triple clamp powdercoated, and i am now having issues installing that damn steering stem again! It was a mess to remove, i used heat and a hammer and some hard knocks. My triple clamp is the adjustable one with either 16 or 22mm offset, but it...

Looking for a steering stem top nut to fit my 97 fe501e. The nut that holds the top triple clamp down. It was missing when I got the bike.

I've just re-greased the steering stem bearings on my 2010 FE570 (preventative maintenance) and was after the procedure used to refit the triples, well tighten the top triple to the steering stem to ensure correct pre load on the steering stem bearings. I hope this is easy to follow. I have...

so I'm pretty sure my steering steam bearings are freezing up, time to replace, bike is 2 years old and never been greased except what little was done at factory. question: do I need husaberg bearings ? or would KTM have the parts too? if I do need husaberg parts, where do you suggest...

While working on my brothers forks we thought we sholud grease the steering head bearings, but we cant get the stem out? From what i read the stem is pressed on earlier models, but in the manualt it says that it should be enough to tap the lower clamp lightly and the stem should come out...

How can I remove the steering stem lock on my '97? I am going to do some welding and repaint the frame anyway so a bit of butchery is not a problem.

Hi all, does anyone know for sure if there was a change in steering head angle between '04 and '05 models? I have my berg and my bro-in-law's bike side by side, and it appears that the forks are slightly more raked out on his. It was purchased as an '05, but a few things have caught my...

Did a re-grease & check on my head stem bearings a week or so ago, managed to hold the forks and pack grease into the bottom bearings and do the top bearing / whack a bit of extra grease into the head yube for good measure, so didnt actually remove the whole box and dice. once I had it back...

Hello all I suspect my 06 550 has a valve stem seal which is leaking, upon starting from cold after sitting for a couple of days, she blows smoke for up to 15-20 seconds then clears up, once warm and running there is no sign of oil smoke. The bike had a rebuilt about 35 hours ago due to...

Can some one tell me how to remove and replace the steering lock barrel? I have a new lock assembly keyed to match the keyed ignition... Cheers Mark

I am in abit of a pickle i need some for my bike (2005 650FE) and i didnt order them from my berg man and i need them today. Can i go to the KTM dealer (are they same as 525 etc) and get them from him. If so what part number would i need to quote? Thanks guys...

I've got a 99 fc501, i've pulled the forks off yesterday to put in new seals and noticed the top tripleclamp is loose, the bearings are tight, just the top triple wasn't tightened down well, so i went to tighten it, and the whole bloody stem spins in the bottom tripleclamp, i thought these were...