stay

So I have a 2011 husaBerg FS 570. Bike has been sitting a while, ran before storage.I tried to start it ,it would start but backfire and spit. Head tube was getting super hot. I figured it was super lean.I had already put a new fuel pump in it before but I just replaced it again anyways( has a...

2019 FE570 (70 degree Berg) I plugged in a headlight and it didn't work. Turns out I need the handlebar switch that plugs into the 6 pin connector. I don't need to be able to turn the light off and on. How can I wire the 6 pin connector so my light will light up and stay on once my bike is...

I hope our member Bushmechanic is safe from an out of control bushfire near his home town of Esperance Western Australia, 4 people killed so hope your property and your family are safe mate.

Am I getting the run-around? Does a 2013 FE501 require a battery to stay running?:furious: Of course it needs a good battery to start, or a kick starter, but if you remove the B+, should it stay running?

I had a cold start issue,the dealer took it apart & put in a new injecter. then it started , but wouldnt stay running untill fully hot. He took out the new injecter, & put the old one back in. still wont stay running. he has created this problem but is unable to fix it .It starts right up like...

On my 10 fe 450 the front portion of the seat where it mounts above the air intake wont stay in its mounts after any short ride. Is there a cure for this or is my seat base junk? only 90 or so miles on the machine. I would like to maybe upgrade to a better seat,but it would be a shame if I spent...

Does anybody elses seat slide outta the front guides when you sit on it? Mine wont stay on for anything. I tried a different seat and it still wont stay on....

My 97' FE 400 E will not run right. I can start it but to keep it alive I have to keep it at about 1/4 throttle. It spits and runs hard while occassionally back firing and then it just completely dies - and then sometimes slowly emits a white/gray smoke out of the exhaust. To fix this I took...

hi. im putting my husaberg together, got the new parts today. I had a problem that 2 of the shift drum pins were loose and they broke position star. Now i dont trust that pins would stay in its place only by pressing them in and position star on. Does the position star really lock them in or...

Hi guys As I was wondering in the members gallerys, I had a thought I would like to share ! I have one 02' FE400 with a lot of changes, but nothing close to what I've seen. I've seen amazing stuff like DOHC, home made heads, 700cc bikes, etc..., most of the things are home made, I'm sure with...

From memory the 07,06, and maybe some 05 bergs since the new (pre 09) motor 2001 are ok, but 01 to 04 were to stay away from. Can't remember why. Does anyone recall any major problems with the 04 650FE?? Enough time has gone by to know for sure by now? I thought the big 650 did not have main...

after a week long battle with joeracer.com, I finally got them to ship me an oil cooler. That was about a month ago. With poor written instructions and incorrect installation instructions from joeracer on the phone I finally got it installed on my FS650. after a tip over last week resulting...