started

Before I go and tear my bike apart, I thought I would check with the board to see if anyone had some advice. I hadn't started my bike in about two weeks and decided to get it out and fire it up. It fired right up with no issues and ran for about 3 minutes before I shut it off. I went to start...

I noticed my idle wasn't quite right last time out, but the bike seemed to run fine. I took her out this morning and the idle was not right again. I pulled out the cold start and ran it for a minute, then turned it off and went for a ride. At first the bike felt a little flat in the mid range...

hi all my body ready to ride again and hope u guys can help i have a 2005 650 and its not been stated for 2 years what should i do to it first before i started again i put in a new batt, today and change the oil and filter but before i start it what should i do next????.........Thank you all

Found this today and before I got past the drawing I could not help but think that I have seen this design recently. http://www.motorcycledaily.com/28august ... esigns.htm They do mention Husaberg but I wonder how they could get a patent..??

Pretty cool ... click the pic

hello everyone , just got my fisrt berg a lovely fx470 , but i noticed when i followed my mate on it that it smoked a bit as the bike reved out and when you start it from cold it will smoke a bit when reving it (black smoke ) , its also a pig to start when hot , i have changed the plug for a...

No intention of stealing the UHE's thunder :)

The 400 finally started. $450, 15 phone calls, and a few trepidations later, my bike is running. The "NEW" stator/flywheel is a joke. My old parts had less dings, scrapes and bare spots. BMG says that's how all the new parts look when they get them. Maybe that has something to do with all...