spindle

Is the chain adjusting block (the gauge against the swinging arm) fixed on the non-threaded end of the rear spindle? If so, how do these fit? https://www.ebay.co.uk/itm/163523501059

Does anyone know the correct name or even a part number for the oil seal that sit behind the gear lever as mine leaks when on side stand it a fe 350 2014 Thanks phill Sent from my iPad using Tapatalk

Not sure the proper term for it, but is the lowest section of the fork removable? And if so, how? I would like to change from a radial to axial brake mount and have the other type on another set of forks if it's possible to change without changing the whole lower section and having the forks apart.

I have Brought some new forks for my bike and have now realised that the forks are the later type with the bigger spindle and my supermoto (ktm/behr) wheel is earlier with the smaller spindle. Is it posible to retrofit the wheel into later forks and what is involved? thank you.

Hi all, Can any body tell me if it is just a simple bearing, dust seal and spacer replacement to convert from 20mm to 26mm wheel spindle size. Regards Sparks.

Hi, I'm removing the engine from my 1999 FE501E for a general overahaul. I've got everything disconected but cannot get the swing arm spindle to slide out. This is unlikely to be the first instance of such an issue. I'm assuming corrosion. Does anyone have any advice or tips on how to...

just looking at the rear wheel spindle travel and spotted two machined holes just above the adjustment cutaway. never seen it written but are these the maximum and minimum that the factory want the spindles to go backwards or forwards? or were they for machining? regards Taffy