spacer

Hi When i assembled the two housing halves, i could not turn the balancers shaft without using a spanner. I remember there was a spacer when i disassembled the balancer from the crank, and i did put it between the crank and balancer. Is that right? I assume i should manage to turn around...

Hi all I am in the process of replacing my front wheel bearings and seals (2013 FE350). I will also replace the external spacers as mine have been chopped out a bit. I have driven the bearings in until they contact the lip on the inside of the hub. How much of a gap (if any) should...

I have just replaced the rear wheel bearings on my 09 FE450 and found that the rear hub spacer appears to be to long and the bearing that doesnt have the circlip cant be pushed all the way in until the outer race bottoms out in the hub. How do I know that I havnt put to much side load in the...

so i thought this might be of some interest for people with pre 03 husabergs wanting to fit newer wheels from ktms. last night i bought some wheels (26mm spacers) from a 2011 ktm they were talon hubs, ... and i made them fit without any money spent. ok the rear wheel although being 26mm had a...

Between the needlre rollers in the swingarm there's supposed to be a tiny spacer. When removing the old bearings one of min disappeared. Has anyone got one to spare?

When popping out the rear wheel bearings on my 97 it seemed as though the hub spacer may be slightly too long. What leads me to believe this is before I removed the bearings it felt as though they were seized. Both were very hard to turn by hand. But once removed the wheel bearings spin freely...

I ride a lot of trails up in the Sierra mountains that are littered with rocks and logs. We even have areas that we call rock gardens that are just wide trails made up of loose rocks from 24" to 4" in diameter. To ride through those with any speed requires very supple suspension settings. The...

Sticking my SM wheels back on for an MOT on my 2002 501e (replacing bearings all round on the enduro ones and neither tyre is road legal)... Now I'm sure I /did/ have a spacer for it as there's no speedo drive .... and it's probably with the calliper bracket that I also can't find at the...

hey there guys, i am seriously thinking of removing the counter balance on my 2002 fe501 and was wondering wether the spacer can be the bearing that normally sits there or does it have to be made out of steel ?? i am going to be getting the crankshaft balanced after the balancer removal...

can someone find the width/dimensions of the spacer would be if the counter balancer c/w bearing are removed? had a good look but couldn't find it. it's out there somewhere! regards Taffy

I decided to remove the rear axle and give it a good cleaning and greasing back when I had the old engine out.The spacer on the right side seemed to be stuck to the axle.I could move the axle with difficulty using a hammer and a length of wood.The spacer seems to be the main problem.I need to...