simple

2004 Husaberg FS650e Hi all, of late my bike will only start on the button with a jump start or a top off from the charger, a problem that I put down to a faulty and old battery. So I replaced it yesterday with a battery with slightly more cold crank amps and assumed that would be the end of...

I was puttering in my garage yesterday and fashioned a simple windscreen for my 570. The bolts for the bark busters hold it in place, so it's a quick two-bolt affair to remove and install. It's 14 inches wide and extends 8 inches above the top of the number plate. Haven't had the chance to...

This is hard to admit but might save someone from a long walk I know you should not ride along but I do sometimes Today I had a 12 mile walk out of the desert to my truck. I could drive to within 2 miles of the bike . It took as long to 4 wheel to the bike as it did to walk out, rough terrain...

Ok so had first ride on my bike today and sweet mary its got some poke ! after i had pulled up back at my house i noticed the tickover was quite high. the throttle had returned to its normal snapped back position, and the choke was obviously in as i only used it to fire it up then shut it...

fe400e 2001: The bike was rebuilt 15 hours ago. It is difficult to start until i clean the plug, then it runs ok, some smoke but not loads. The plug is black and wet, and if I look into the cylinder then it is wet and black also. The dumb question is how do I tell if its petrol/carbon (it...

I have about eight hours on my rebuilt fc600( scary fast by the way 8O) and I'm doing my first valve adjustment. I used the 1/8 turnout method, locked the nut, double checked w/ .004 feeler. The gap seems perfect, slight drag. My first question: Is it normal that with it adjusted as said that...

can u remove the cam without splitting the chain ?& how easy do the bearings come off the cam. as i have already fitted chain 2hrs ago when i realized the cam was on its last legs.

If when raising the air speed or pressure through the venturi (venturi signal?), by means of increasing displacement, a leaner setting is required (everything else remaining equal). Then why is it necessary to sometimes richen the A/F mixture when the displacement remains the same but a free...