signal

anyone have a wiring diagram for a euro fe390 or know what wiring colours are for turn signals and location of plugs? One of the bits I need for road legal so want to get them sorted soon:(

Doing a supermoto conversion this winter on a 2007 fe450 usa version. It came with headlight and tail light but I would like to change them all to LEDs and add signals and a horn. I've searched forever and can't find the exact output of wattage on the lighting coil, it is currently torn apart...

My turn signals lasted all of about 10 seconds into my first ride before the supporting plastic broke and they fell off. And it appears the rear brake light is also too heavy and starting to crack the supporting plastic. Wondering if there are good options for a 2011 FE570s that are lighter...

I have a 11 Husaberg 390 FE, I have made the bike street legal, all signal lights (I am using led signal lights and I did install a led flasher) etc work perfectly. I decided to put in the signal light green lense on the factory dashboard, as soon as I installed the bulb I started the bike and...

This morning while riding to work, I noticed that my turn signals were not functioning, including the dash light. When I got to work and turned the engine off, I checked them and they were working. Started the engine, and not working again. What would cause them to only work with the engine off...

I am finishing up my enduro lighting system on my 2007 fe 550, and my turn signals work great; however when I turn on the front headlight (hi or low) the turn signal stays solid (both L or R)...any ideas? thanks

I have a new to me 2005 FE550 with a lighting/signal kit installed. When I bought the signal lights weren't on, but the switch and wiring were present. I have been through the whole system and referred to the wiring diagram, but can't get the signals to light up at all. I've connect an ohm...

Howdy all, I have all of the Husaberg turn signal wiring harnesses and the turn signal switch to add turn signals to my 2010 Husaberg FE 390 (USA model) ..... .... but can't find the dang power plug-in for the harness! I even have the gas tank off and looking below it. Found the plug...

I have an 05 FE450e I would like to put signal lights on it Does anyone know if the wiring harnes is pre-wired for signal lights? Has anyone put signals on their Berg and how or what did you use? I also would like to put a high low headlight on it. Any ideas? Thanks in...