shafts

some will have noted that the 1989-2003 rocker shafts have stopped. the later 2004-8 will fit instead but there is no oil feed. all I can suggest is that you drill out the hole on top of the rocker arm and give the entrance a nice bevel to catch as much splash as possible. if it is...

Will any over kick start shafts fit a fe650 03 I can't find 1 And I am not paying 312 pound plz let me no or no any one that breaking one or where I can get one from thanks

I'm reassembling the gearbox on my 2002 650 and there is a washer that was between the input shaft and the bearing on the clutch side(inside the cases), this is not shown on the husaberg parts manual so It has either been put there in error on a previous rebuild, a modification to stop the shaft...

ok guys, I need some of your opinions here. Got my 08 FE550 brandnew, and from the very first start-up, the engine was burning a bit of oil. So far no problem, as it takes some time for the liner/piston to be matching. @ about 30 hours, it became better (no smoke when coldstarting or going...

Hi Everyone, The saga of my FX 470 rebuild on the cheap continues. I noticed some roughness in the rocker roller bearings and upon inspection found flat spots on both of the central shafts of the bearing. No wear was detected on the needles or outer race. New bearing assys were about $70NZ...

just wondred if you make a point of turning them over.... do you get just spindles or spindles and re-bush the rockers? anyone meddled here? i just turn them on their axle 180d to change the wear points. what about the rocker shafts themselves....do you have a favourite as they...