sag

Hi all I'm on a 2010 fx450 that I've picked up and just serviced the shock.Im now just setting it all up I've put in a lowering kit in the shock but is there a way to set the sag without removing, the shock to adjust,I've had a reasonable look and can't seem to find a easy access so any ideas...

I put my bike up on the stand found my zero mark with my sag gage. dropped it down sat on it in my normal position, fully geared up. I am only seeing about 60 mm of sag. I spin the adjuster up a lot of turns to get me around my 110 mm sag mark. when i put the bike back up on the stand i can grab...

So my sag isn't set correctly, hardly has any sag, standing sag is 10 mm, so i went top adjust my rear spring and it is too small so i cannot increase the sag, where do i go from here, will i need a new spring, how do i tell the size etc etc thanks :unsure:

Hello folks from suffolk..uk Now that I got my fe 650 to start hot or cold within the first two kicks im finally started to enjoy riding it..:)..now wanting to look at suspension settings.. Basically theres no static sag in the rear..the moment I lift the rear end ( holding frame under...

As the title says, I need to pick the brains of the motard group.;) My FS has a 32-89 riding sag front to back, the manuel says should as close to 90-90 as possible. Previous owner raced the bike........so i was wondering if this is a race setup or just waaayyy out of wack. The bike handeles...

Decided I should set my static sag and rider sag on my Berg 390 Peeps on here suggest 35mm rider sag and 105mm rider sag. I've took the shock off to alter the preload on the spring, managed to get 106mm rider sag, but my static sag is 27mm. To achieve my rider sag I'm losing my static. It's a...

On a 2010 FE450 - I had my rear shock and front forks lowered 1.5 inches. I'm vertically challenged witrh a 30 inch inseam and in very tight technical terrain the stock bike was way too tall! The rear shock was re-valved when the lowering was done, but they asked me to try using the stock...

With a progressive spring, do you set sag the same as always? Sag is sag, right? Just got my suspension back and had to put in a lot of preload to get the race sag right; now bike sag is 1/2 inch. That means the spring is too soft. But, when setting sag, I'm in the soft part, so that makes...

I know another sag question, I've read manual, looked on site, etc. but all on larger weights so please give a gal a hand. :( 2010 FE 450, I weigh 145 lbs with gear on! I bought a PDS 5 from Enduro Engr. and using 8 mm preload I get 54mm static sag and 63mm race sag. Played around with...

Hey Just got a FE450 11 and got some slight upgrade in springs .52 front and the psd30 on the rear. I think the sag is around 105 - 115mm on rear (cant remember which one). Now, I have heard that having a progressive spring on the rear means you cant actually get the sag to be correct...

Is there a trick to adjusting the sag, without taking apart the back half of the bike? I just don't see any way to get to the collar on the spring? Thanks for the help!

How much should the front fork sag under riders weight? How do you mesure it?

Hi guys, probably gonna get shot down for askin basic questions but hey, what the heck :bounce3: Ive got these measurements ... 630 on stand 552 race 600 static Need to get towards 85 -100 race which will obviously alter static, but i wondered if it was possible to not have enough tension...

Can anyone give me the sag setttings for the fork and shock on a 2008 Husaberg FE 450? Rider sag and static sag. thanks HusaRod

Im after a bit of advice on sag settings for my 03 FS650e. I hadnt touched the suspension since i bought it, and it has always suffered from a bit of headshake at around 80 ish, but since fitting new tyres it has got rediculous, i had a big moment last night which made me think i should do...

I reset my race sag recently on both my bikes. It seems that both of them had settled from 105mm to become 115mm. I had installed stiffer springs on both of them and my guess is 8 months or so has gone by. I set the Berg again, this time at around 100. I think it should stay for a while now. I...

Well, Yesterday, I got my head into shape and decided to set the sag settings on my FE550e '05. It took about 4 Hours tops from reading all the relevant looking forum posts here on UHE, and going over the manual, and some testing. I am BLOWN AWAY at the difference that such a small...

Carrying on from my post and information receivedHERE and with the benefit of the WP spring chart found on this site: ... it appears I need the 97-250 spring (part number 9121.0008) for my 97kgs of mass. I presume that the weight's they're suggesting are net of gear because at a rough...

I was doing a basic setup check and found my forks to have 38mm of static sag, the wp book says the sag should be between 25-40mm. I like to run around 25-30mm,(to keep the fork in the plushness of the stroke) but I can't shim the springs enough to get that, and I really don't want to put 4.6...

it appears that there was so much confusion over the rear shock sag on the '03-'05 KTMs that the factory did a dealer bulletin to explain. simplified: it turns out that 115mm was the correct sag. considerably more than huseys run i believe. what is the quoted sag for the huseys around...