run

I started up my FE450 and rode for about a minute then stalled, bike is well maintained and always runs flawlessly. I pulled the fuel line off at the filter and it flows fuel when I crank it (not sure how much pressure its supposed to have but seems ok) It fires right up with a shot of starting...

Hi all, So this 2002 FE650 had been sitting in a corner for the last 6-7 years because of a small crack in the head where the cam chain guide sits. According to the owner that was the whole reason it was left sitting. I got the bike over to my place and went through the usual just to see if...

My Berg had no problems using the electric starter in Florida where the temps rarely went below 70 degrees. Now that I am in California I am now looking at starting when it is in the 50s. My Revloc clutch puts a lot of drag on the starting mechanism so now with a cold Berg the starter spins...

Fe 450 .. Just wondering what everyone is running for oil it says in the manual to use motorex 5w40 or 10w50 just wondering Has anyone every used anything besides that with no issues? Like 10w40 or any other name brand oil I can’t seem to find motorex at any stores just online. There’s a Yamaha...

I seem to have an electrical issue causing the engine to shut down after starting. The battery is fully charged - checked, start the engine - runs for approx. 3 seconds and then shuts down like the kill switch is activated. does this until the battery runs flat. I have just finished installing...

Hey, has a fe570 09 mod. it suddenly stopped for me the other day and found out the day after the battery was the problem. The bike started after new battery, but now it starts, but only for a few seconds. has anyone an idea what it could be?

My lovely husaberg Fe450e 2005 won't run at idle speed, starting it is really difficult, i just cleaned out the carb and everything looked fine while it was appart. The bike was behaving the same before i cleaned it. Could anybody give me some advice. I'm new here btw :D It started fine...

Guy I just bought my bike from screwed me looking for a drop in ready motor for an 05 fe 650 e

Thought i may have a cooling system problem when i got my 650 but just realized that the exhaust gets alot hotter thrn my 550 who else has experienced this?

Hi, I have an fe450 with a gremlin I cannot find. It will run fine,you stop for a break and the fuel pump won't kick in. So I have replaced the fuel pump still did it,replaced the whole wiring loom but went out today and it did it again. Got home and it fired up again. Starting to ****...

hi can anyone help I have a fe 250 2014 I had a day riding at tong it went great got home washed it started it about 10 mins then stopped it went back a week later and it will not turn over on button but can short out on selanoid it turns over but will not start help please

Hi bergers, I was riding my 2010 FE390 today for about 1/2 hour when the engine suddenly cut out and wouldn't restart. Dragged it home, found that fuse F2 is blown, and blows whenever I crank the starter. Where should I look for the problem? It's not the fuel pump, I disconnected it and the...

Thought I'd put together a highlight reel of a ride earlier in the week. N1ghts has provided inspiration with his awesome camera work. Thanks mate ! :cheers: https://www.youtube.com/watch?v=Qmeq0oGVsRw Man I had some drama doing this, the gopro editor is full of bugs, I cant figure out windows...

Hi guys, Just a quick question. Im going for a high compression piston on my engine rebuild. the starter will NEVER turn it over. Im wondering if the bike can run without a battery? Kickstart only? Bike: 2002 FS 650 SEM ignition

Hello, first of all I'd like to say what a great resource this is, just bought 07 650 last week so I'm new to the forum and this is my first post. The bike starts easy on the button when cold but after a few mins begins to bog until the engine cuts out.I'm told by the previous owner that the...

Getting my tank back on my FS650 and trying to run the fuel lines back to the petcock. Cannot, for the life of me, figure out how to run these lines so they stay away from the exhuast and dont melt, and in a way that they will actually connect back to the petcocks without any kinks. Also I'm...

Hi guys, Hope you may point me in the right direction. I have a 2010 fe 390 that will run for 10 minutes then just die and won't restart. It will finally restart 4-5 hours later and run fine for 5-10 minutes the repeat same problem, Would love any advice or where to start to find the...

Here are the details: '09 FE450, 104hrs, valves are in spec. History: - Got the bike, did some early spring bushwacking, gas boiled, stuck in woods until it cooled down, not a good first ride. Wrapped the exhaust, seemed to work. - First enduro, bike ran fine, rider didn't do to well. - First...

I have posted several questions and have gotten no response. I must be doing something wrong. If ANYONE sees this post make a reply just as a test. I need help to test my ignition cdi and coil but don't know how. Am I wasteing my time typing in the sky? sonnyk210

2001 husaberg won't run. new battery, starter, plug. two race techs have tried can't find answere. i'm really bummed.