revs

Hi Guys, Need some advice on possible fix. Rode my 99 FE 600 today, Has new plug, clean left air filter, top filter basically blocked off waiting on replacement, New 98 oct fuel. Kick starts easy without the choke. Idles nicely, runs well when you don't rev it much and use the torque to push...

Does anyone know what would be considered maximum safe revs for a 650 berg? (Yes I know nothing is safe!) I've fitted a rev counter to my track bike and don't know what to set as a limit, a rough idea helps with gearing. Would there be a difference between the 628 and the 644, long and short...

I was wondering what my revs will be if i put a 16tooth front and 48 tooth rear at 85km an hour? Any idea? and what do you think a comfortable cruising speed will be with a 16/48 tooth setup? i do a lot of highway driving and want to find a comfortable speed that doesn't stress the engine and...

Hi, I've just swapped from an 04 fe380 to a new 07 fe 450. I'm going to fit a Vapor unit, partly for temp checking and partly for showing revs. There is a facility to set "shift lights" at the revs you determine. Question is, at what revs is a 450 at the top end of its power or...

This is a multi-part question, more accurately, this post contains many questions. I have an '06 FE650e and I am currently in process of installing a jet kit from Mr. Lineweaver. No questions there (at this point), but it made me think that this is a perfect time to resolve another issue...

I have a noise that seems to be only noticeable when at low revs chugging a transport section, on a positive throttle. if constant throttle no noise!!! Ive tried every bloody bolt....but nothing. Its been like it for 6 months and nothing has gone snap...any suggestions. When riding it sounds...

Hello, stock fc470 -02 - max revs - peak power revs - safe revs? I'm trying to calculate gear ratios for Iceroadracing. Should top about 170km/h. Back tire -105/90-19 regards, Jarkko

Hi guys any advice. On my 1999fee berg when I shut the throttle (round slide dellorto) the revs take a while to slow down. This is a new problem. The idle is good when it gets there. The valves are adjusted right. I know idle can change which is a sign of tight valves, but this is perfect...

Hi I am kind of a rookie when it comes to Husaberg. My FS 650 -04 seems to have some ignition problems. Mostly at low revs, or at least it seems like that (I suppose it don't feels as much on higer revs). The bike stalls on low revs. I very recently have the carb dynojet-tuned with exellent...

Hey Guys, Here is another problem I am having. When I try to give the bike full throttlle (or anything over half throttle) from a low to mid rpm, it will just die. I have to slowly twist the throttle to get the rpm's up without it dying out. Is this a trait of not having a carb with...

Just to update those with an interest, Replaced my rocker arms on my 2002 650 SM. They were fine, no play at all. The new rocker arm assembly were though. The new exhaust rocker had so much play on the shaft I sent the thing back and the new one was fine. Watch out for this, check the radial...