retaining

Hi All, Can anyone supply accurate dimensions of the clutch retaining ring, that lock in the half washers on an 03 Fe 501? While doing some clutch work we have lost the original so may make one? Any available out there hopefully in NZ would be even better (part # 23016401) Thanks

Is there a Napa or generic part number for the circlip that retains the impeller? Or perhaps just the dimensions? 54 0471 100010 SICHERUNGSRING DIN0471-10X1 CIRCLIP DIN0471-10X1 I tried having my local napa match it, and while they have boxes and boxes of circlips, they couldn't make any...

I am having troble finding the part number for the rear brake pads Retaining plate set. I't is not in any of the part manuals i have, they only show this set for the front but no mention for the rear. Part no for the front 546.13.212.000 Regards The Force

I have decided to do a bit of maint on the little berg. This mainly came about when i noticed the head bearings were shot. I have pulled the carb of to see if i can fix its nasty problem of low bog, popping and farting and being very hesitent and basically unrideable at or around the 1/4...

Hey Folks, Not sure if you have ever experienced a cracked kickstart retaining washer? Thanks to my ham fisted ways....i have. After much searching I found a good quality hardened washer that will replace the stock one. It is Caterpillar part # 9X-6165. It appears to be an "in stock" item...