recommendation

Can someone make a recommendation for a chain roller replacement (part number 120 056-01) for my 2002 Husaberg FE650e. I checked with the local KTM dealer and he could not find the part number or my bike. I found plenty online but without measurements I cannot make sure it will fit. Seems...

The original battery is shot and it never did seem to have good cranking power. What would be a good battery to go with? Of course it has to be an exact fit to get in the very tight compartment. Thank You!

So first of all I apologize for any stupid questions I have. I did searched the forum and online, but was hoping you guys can help me out here: First question. I currently have a AC-10 rear on my 08 FE450 which is 110/100-18. waiting on the shelf I have a 120/90-18 AC-10 and I'm trying to...

Hi guys Looks like the battery I got from the local auto parts store 2 years ago is dead. I'm looking for a new one and noticed a lot of people recommended shorai which looks very impressing but a bit out of my budget right now. Is there any other, less expensive batteries you guys could...

On a 2010 FE450 - I had my rear shock and front forks lowered 1.5 inches. I'm vertically challenged witrh a 30 inch inseam and in very tight technical terrain the stock bike was way too tall! The rear shock was re-valved when the lowering was done, but they asked me to try using the stock...

Hi guys. I recently installed a cyclops race light on my 2009 fe 570. It comes with a h4 bulb, and was wondering what h4 bulbs you guys have liked. Very little of my night riding will be above 60 mph. Most of my riding will be in the woods, or county roads to get home.

Gday, Ive got a new 09450FE to run in and I want to do it right, so Ill drop the oil and filter after the first hour of use. Which type of oil should I put back in after this first hour to continue running in, as the manual dosn't say, I have heard stick with 100% mineral oil for break in, or...

Hi folks, I need to raise my (FX501) bars about 1.5". Anyone have a oreference for bar risers? thanks, Walter

As I have removed the starter assembly (paper weight), I'd also like to replace the battery with a smaller model, and to relocate it under the seat. Basically I need it to run the lights as well as a GPS V Garmin unit. What do you recommend I use to hold the battery under the seat and what...

As my no1 engine blew up at the Dyno last Monday a have to use my spare engine for the practice next Monday. There is a 2004-piston in it (the concave shaped dome). I have no experience with using the lower compression ratio that piston gives. If I remember correct it was around less than...

Hi Guys I have to change the main bearings of my Berg FE 600 98 model, but I have some doubts about the best option. 6206/C3 or C4?? Bearing with steel retainer or resin retainer?? Please give me kindly some advice!! Thanks a lot form Spain!! Chichor

Could I get some recommendations for a quality cam chain breaker and press for reassembling or is there one tool that will do both? Thanks, Eric

I am thinking of purchasing a new FE450 or FE550. Can anyone recommend a dealer in New England ( USA ) ? Thanks.

Has anyone tried following the instructions in the owners manual for stator life? The manual for my '99 FE400E states on page 48, which is a wiring diagram page "Note! The alternator delivers 70W in each of the yellow wires. Only one of these is connected from the factory. Both wires only to be...