put

Hi If i want to put in a start motor at my husaberg 650 fs engine from 2002, what i need? Is it enough with a start motor and wiring and battery? Or do i need some sprocket or things like that? Emiiilz

Looking to put a set of sticky's on my fe450. Not sure what sizes to run, any help would be appreciated. Running stock excel rims: Front tire: 90/90-21, rear tire: 140/80-18.

As the post says, I've been trying to get my 05 650 back on the road. I went into the clutch side to replace the WP seal. I've been careful to check kickstart shaft, and check for proper movement prior to installing the cover. Plug out of course. When I install the cover and seat the...

Just reassembled my engine. It runs fine now, but the valve rockers don't seem to be getting as much oil as they used to. I didn't check the head gasket when I put the head back on. Is it possible to get it on backwards without knowing? From the outside, the gasket appears to follow the head's...

On my 10 fe 450 the front portion of the seat where it mounts above the air intake wont stay in its mounts after any short ride. Is there a cure for this or is my seat base junk? only 90 or so miles on the machine. I would like to maybe upgrade to a better seat,but it would be a shame if I spent...

My long legged Swede was not happy with our warm temperatures. I mistakenly topped her up and ran a couple miles to downtown. Had fun ripping through traffic, especially past some jacka$$ cutting around cars in his new CL. When I slid to a stop and parked the bike she spit out a bunch of...

Just replace a cam chain looked like the cam was 180deg out lined up dots on crank sprockets and the cam was dot how its pictured in manual. I set it up as pictured in manual and set the two dot level with head face.in any ideas why this might be the case?

What would be the best spot to put a Selco temp switch that closes at 190F and opens at 160F, in a DIY fan configuration? I was thinking about putting one by the inlet (where the coolant arrives from the pump). But at that position, would the temperature rarely go under 160F? I could also...

anyone know if they fit ? I have saw pics of bergs w/ blue rad lines & oil lines .

well i've gone and done it... listed her on e-bay, dont know whether to laugh or cry.... sure i'll get over it when i get my new berg! anyone fancies sticking a bid in to help me out feel free, anything up to 500 quid and yr in no danger of buying it. i'll let you know what my new ones like when...